Motorola MBP25/4 Manuale d'uso - Pagina 10

Sfoglia online o scarica il pdf Manuale d'uso per Baby Monitor Motorola MBP25/4. Motorola MBP25/4 27. Digital video baby monitor
Anche per Motorola MBP25/4: Manuale d'uso (30 pagine), Manuale di avvio rapido (2 pagine), Manuale di avvio rapido (6 pagine), Manuale di avvio rapido (8 pagine)

Once the baby and parent units are switched on, the display on the parent

unit will show the video captured by the baby unit.

If there is no connection or you are out of range, the video display will go

off and the symbol

every 9 seconds. (If the unit is on scan

Move the parent unit closer to the baby unit until the link is re-established.

Press and hold the P POWER ON/OFF button, until the progress bar

scrolls fully across, to turn OFF the parent unit.

NOTE

The battery icon

and it gives a beep every 16 seconds. The battery needs to be recharged.

battery pack takes about 16 hours to charge fully.

When charging

If the parent unit is turned OFF, when the adapter is plugged in, it displays a

"mains plug" icon briefly, then a large battery icon with internal segments

cycling for 60 seconds, before the display goes blank, but the unit

continues to charge. The Blue LED at top left corner lights up to indicate

the adapter is plugged in.

If the parent unit is turned ON, when the adapter is plugged in, the battery

icon in the screen's top right corner will show that the battery is charging by

cycling the internal segments. The segments stop cycling when the battery

is fully charge. The Blue LED at top left corner lights up to indicate the

adapter is plugged in.

2.4

Registration (Pairing)

The Baby Monitor camera is pre-registered to your Parent Unit. You do not need

to register it again unless the Baby Unit loses its link with the Parent Unit.

To re-register your Baby Unit, or register a new Baby Unit, follow the procedure

below:

button of the parent unit and then press the - DOWN button

Press the

to select the ADD CAMERA icon

will pop up, press the + UP button or - DOWN button to select

2. 1 / 2 / 3 / 4

the desired Camera identification number and press the

will flash on the LCD display, and the unit will beep

turns RED and flashes to indicate that the battery is low,

the

symbol displays.)

, and press the

button to confirm.

button to start

Getting Started