Motorola ASTRO XTS-5000 Manuale di cura e risoluzione dei problemi
Sfoglia online o scarica il pdf Manuale di cura e risoluzione dei problemi per Radio Motorola ASTRO XTS-5000. Motorola ASTRO XTS-5000 2. Motorola xts5000 portable radio
Anche per Motorola ASTRO XTS-5000: Manuale operativo (5 pagine), Manuale di avvio rapido (4 pagine), Manuale di modifica (3 pagine)
Stampa la pagina
Motorola XTS5000 Portable Radio Care and Troubleshooting
Radio Care
The XTS 5000 radio casting has two vent ports that allow for pressure equalization in the radio. Never poke these
vents with any objects, such as needles, tweezers, or screwdrivers. This could create leak paths into the radio
and the radio's submergibility will be lost.
(For XTS 5000 R Radios Only) The XTS 5000R radio is designed to be submerged to a maximum depth of 6
feet, with a maximum submersion time of 4 hours. Exceeding either maximum limit may result in damage to the
radio.
(For XTS 5000 R Radios Only) Elastomer technology materials used for seals in rugged portable radios can age
with time and environmental exposure. Therefore, Motorola recommends that rugged radios be checked annually
as a preventive measure in order to assure the watertight integrity of the radio. Motorola details the disassembly,
test, and reassembly procedures along with necessary test equipment needed to inspect, maintain and
troubleshoot radio seals in the radio's service manual.
If the radio battery contact area has been submerged in water, dry and clean the radio battery contacts before
attaching a battery to the radio. Otherwise, the water could short-circuit the radio.
If the radio has been submerged in water, shake the radio well so that any water that may be trapped inside the
speaker grille and microphone port can be removed. Otherwise, the water will decrease the audio quality of the
radio.
Do not disassemble the radio. This could damage radio seals and result in leak paths into the radio. Any radio
maintenance should be performed only by a qualified radio technician.
Handling
Do not pound, drop, or throw the radio unnecessarily. Never carry the radio by the antenna.
Avoid subjecting the radio to an excess of liquids. Do not submerse the radio unless it is a ruggedized, XTS5000R
model.
Avoid subjecting the radio to corrosives, solvents or spirits.
Do not disassemble the radio.
Keep the accessory-connector cover in place until ready to use the connector. Replace the cover immediately
once the accessory has been disconnected.
Troubleshooting
Symptom
Radio Dead; Display Does Not
Turn On
Radio Will Not Turn Off
Radio Dead; Display Turns Off
No Receive Audio or Receiver Does Not
Unmute
Audio Distorted or Not Loud Enough
RF Sensitivity Poor – Does not receive
radio traffic.
No RF Power Out – Poor transmit range.
No Modulation; Distorted Modulation
Bad Microphone Sensitivity
No/Low signaling (PL, DPL, MDC)
No "
" on Radio Display When
KEYLOAD
Keyloading Cable is Attached to the Radio
Side Connector
Keyloader Displays "
."
FAIL
Possible Cause
1. Dead Battery
2. Blown Fuse
3. On/Off Switch
4. Regulators
VOCON Board
RF or VOCON Board
Programming
Synthesizer Not On Frequency
1. Synthesizer Not On Frequency
2. Antenna Switch/Connector
3. Receiver Front-End Tuning
1. TX Power Level or Frequency
2. No Injection To Power Amplifier
3. Antenna Switch/Connector
1. Programming
2. VOCON Board
1. Check Deviation and Compensation
2. Microphone
1. Programming
2. VOCON Board
1. Defective Keyloader Cable
2. Defective Radio
1. Wrong Keyloader Type
2. Bad Keyloader
3. Defective Radio
Correction or Test
Replace with charged battery.
Send radio to the Radio Shop.
Send radio to the Radio Shop.
Send radio to the Radio Shop.
Send radio to the Radio Shop.
Send radio to the Radio Shop.
Send radio to the Radio Shop.
Send radio to the Radio Shop.
Send radio to the Radio Shop.
Send radio to the Radio Shop.
Send radio to the Radio Shop.
Send radio to the Radio Shop.
Use correct keyloader type. Refer to
Keyloader User Guide for more
information.
Try another keyloader
Send radio to the Radio Shop.