Motorola MaxTrac 100 Manuale di istruzioni per l'uso - Pagina 26
Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Radio Motorola MaxTrac 100. Motorola MaxTrac 100 37. 6-frequency conventional fm radio
Anche per Motorola MaxTrac 100: Istruzioni per l'uso (2 pagine)
Stampa la pagina
Installation Planning - Mobile Radios
Planning is the key to fast, easy radio installation. Before a hole is drilled or a wire
is run, inspect the vehicle and determine how and where you intend to mount the
antenna, radio, and accessories. Plan wire and cable runs to provide maximum
protection from pinching, crushing, and overheating.
Installation Planning - Base Control Stations
The base/control station option provides the radio with a desk microphone and
power supply for use at a fixed location. All operations are the same as the radio,
except for the desk microphone.
Choose a location for your base/control station as close as possible to where the
antenna cable enters the building. Be sure 117Vac, 60Hz power is available.
Make sure sufficient air can flow around the radio to permit adequate cooling.
Recommended Tools for Installation
The following tools are recommended for proper installation of your new radio.
•
Portable Drill
•
Hammer
•
Center Punch
•
5/16" Hex-Nut Driver
•
1/4" Hex-Nut Driver
•
Phillips #2 Screwdriver
•
TORX
®
Screwdriver, T25
•
3/8" Diameter Drill Bit
•
5/16" Diameter Drill Bit
•
5/32" Diameter Drill Bit
Antenna Mounting
The best mounting location for the antenna is in the center of a large, flat
conductive surface. In almost all vehicles, these requirements are best satisfied
by mounting the antenna at the center of the roof. Some vehicles have a large
trunk lid that provides a good antenna location. If the trunk lid is used, connect
grounding straps between the trunk lid and vehicle chassis to insure the trunk lid
is at chassis ground. See the instruction manual supplied with the antenna for
complete installation information.
24
Installation Planning and Procedures (cont.)
Installation Planning – Mobile Radios / Installation Planning – Base Control Stations /
Recommended Tools for Installation / Antenna Mounting