Epson 1280 - Stylus Photo Color Inkjet Printer Manuale di istruzioni per l'installazione - Pagina 4

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Software Epson 1280 - Stylus Photo Color Inkjet Printer. Epson 1280 - Stylus Photo Color Inkjet Printer 8. Product support bulletin(s)
Anche per Epson 1280 - Stylus Photo Color Inkjet Printer: Sostituzione delle cartucce (2 pagine), Bollettino di assistenza prodotti (6 pagine), Bollettino di assistenza prodotti (1 pagine), Manuale supplementare (1 pagine), Manuale d'uso (27 pagine), Manuale di compatibilità (1 pagine), Manuale supplementare (2 pagine), Inizia qui (2 pagine), Opuscolo e specifiche (2 pagine), Informazioni sul prodotto (13 pagine), Iniziare qui Manuale (6 pagine), Specifiche tecniche (2 pagine), Manuale d'uso (12 pagine), Bollettino di assistenza prodotti (3 pagine), Bollettino di assistenza prodotti (2 pagine), Bollettino di assistenza prodotti (4 pagine), Bollettino di assistenza prodotti (7 pagine), Manuale introduttivo (32 pagine)

Attach the small tube bracket on the top of the printer to the right edge.

Install Tubing in Bracket and Adjust the Slack:

5. Put a little alcohol on the tubes at the position that will interface with the bracket.

For the 1270/1280/1290 printers, do not rotate the tubing. Slide the tubing into

the tube clip attached to the underside of the bridge bracket. This is the bracket

you installed in step #4. With the cartridges still in the left hand position, make

sure there is a little slack in the tubing, not a lot, but just enough. If you can't get

the tubing into the bracket, use a little more alcohol on the tubing.

Move the cartridges, by hand, from far left to far right. Make sure there is

sufficient slack in the tubing so that the cartridges can reach the far right and far

left with out putting excess tension in the tubes. If you have too much slack in the

tubes, then the tubing will touch the bottom of the printer. Adjust the tube

position in the bracket so the tubes don't touch the bottom of the printer, and so

the carts can reach far left and right with out the tubes stopping the motion. This

is important.

With the new bridge bracket, the bottom of the printer chassis and the underside

of the tubes must be coated with silicone lubricant. We have included a cotton pad

containing the silicone lubricant. Wipe the silicone on the inside metal base or

chassis (in the center) and on the bottom of the ink tubes. When the tubes touch

the metal part of the printer, they will slide and not stick. This is important.

S a v e

M o n e y

a n d

I m p r o v e

Y o u r

P r i n t i n g

MIS Associates Inc

2901 Auburn Rd

Auburn Hills, MI 48326

800-445-8296

http://www.inksupply.com

Fax: 248-289-6013