Epson 1735W - PowerLite WXGA LCD Projector Bollettino di assistenza prodotti - Pagina 31

Sfoglia online o scarica il pdf Bollettino di assistenza prodotti per Software Epson 1735W - PowerLite WXGA LCD Projector. Epson 1735W - PowerLite WXGA LCD Projector 34. Esc/vp21 command business projectors
Anche per Epson 1735W - PowerLite WXGA LCD Projector: Manuale d'uso (42 pagine), Manuale operativo (47 pagine), Elenco delle parti (1 pagine), Manuale di configurazione rapida (4 pagine), Manuale d'uso (1 pagine), Opuscolo e specifiche (2 pagine), Bollettino di assistenza prodotti (25 pagine), Bollettino di assistenza prodotti (12 pagine), Bollettino di assistenza prodotti (22 pagine), Bollettino di assistenza prodotti (28 pagine), Bollettino di assistenza prodotti (41 pagine), Bollettino di assistenza prodotti (38 pagine), Bollettino di assistenza prodotti (28 pagine), Bollettino di assistenza prodotti (15 pagine), Bollettino di assistenza prodotti (22 pagine), Manuale d'uso (25 pagine), Impostazione rapida (4 pagine)

5. After making sure that Power indicator shows solid orange, remove the USB flash memory

from the projector.

NOTE: Be sure to remove the USB flash memory from the projector. If you follow the

instruction on the step 6 without removing the USB flash memory, the update starts again.

6. Turn the projector off and on again.

7. Display the EasyMP main screen following step 3 and make sure that the version number

displayed in the lower left corner of the image is changed to V110.

The LED lighting status of Projector's USB access indicator.

Green LED lighting: The operating system of EasyMP is being upgraded.

Orange LED lighting: The projector's firmware is being upgraded.

Red LED lighting: The upgrade has failed.

LED is Off: The upgrade has complete normally.

Q1.

How do we know whether the upgrade is complete?

A1.

When green light of the USB access indicators goes off, and the projector power indicator

exhibits a solid orange and enters Standby mode, the upgrade is complete. To make sure

whether the update is complete, please check the version number shown in the lower left

corner of the EasyMP screen. After removing the USB memory or the card reader from

the projector, power on the projector again. When the version number V110 is shown in

the lower corner of the EasyMP screen, the update is complete.

Q2.

Can I use any USB flash memory?

A2.

Please refer to the Confirmation list of USB flash memory devices table below.

FAQ's for EasyMP Update Version 1.10

Page 3 of 5

PSB.2007.06.002