Epson ChromaBlast 1.0 Manuale d'uso - Pagina 10
Sfoglia online o scarica il pdf Manuale d'uso per Software Epson ChromaBlast 1.0. Epson ChromaBlast 1.0 13. For epson stylus pro 4880
Anche per Epson ChromaBlast 1.0: Manuale introduttivo (47 pagine)
Stampa la pagina
EPSON PowerLite Home 10 Projector
Cleaning the Air Filter
If the air filter becomes clogged with dust, it can cause
overheating and damage the projector. Follow these steps to
clean the filter:
1. Press the P
button to turn the projector off, and
Power
wait for the P power light to stop flashing.
2. Unplug the power cord and disconnect any cables.
3. Turn the projector upside-down
4. Use a small vacuum cleaner designed for computers and
other office equipment to clean the air filter. If you don't
have one, gently clean the filter using a very soft brush (such
as an artist's camel-hair brush).
Note: If the air filter is difficult to clean or if it is broken, it should
be replaced. See the next section for instructions.
Replacing the Air Filter
If you need to replace the air filter, you can call EPSON at
(800) 873-7766, or visit the EPSON Store
www.epsonstore.com (U. S. sales only). In Canada, please call
(800) 463-7766 for dealer referral. Ask for part number
V13H134A04.
Follow these steps to replace the air filter:
1. Press the P
button to turn the projector off, and
Power
wait for the P power light to stop flashing.
2. Unplug the power cord and disconnect any cables.
10 - EPSON PowerLite Home 10 Projector
at
SM
7/03
3. Turn the projector upside-down. Push in the tab on the air
filter cover and remove the cover.
4. Replace the air filter with a new one. Make sure there are no
gaps between the air filter and the plastic grill.
5. To replace the cover, insert the tabs and press down until the
cover clicks into place.
Replacing the Lamp
The projection lamp typically lasts for about 2000 hours of use.
(If you use
Theatre Black
lamp lasts about 3000 hours.) It is time to replace the lamp
when:
❏ The projected image gets darker or starts to deteriorate.
❏ The
warning light on top of the projector flashes red at
0.5-second intervals.
❏ The message
Replace the lamp
you start projecting. To maintain projector brightness and
image quality, replace the lamp as soon as possible after you
see the message.
Request replacement lamp part number V13H010L2H.
Note: To view the number of hours your lamp has been used, check
the Info menu.
Warning: Be very careful when removing the lamp. Let the lamp
cool before replacing it. If the lamp breaks, handle the shards
carefully to avoid injury. In the unlikely event that the bulb has
ruptured, small glass fragments may be present and should be
removed with caution. If your projector is mounted on the ceiling,
you should unmount it. This will make it easier for you to replace
the lamp and minimize the chance of any small glass fragments
dropping from the projector.
color mode almost exclusively, the
appears on the screen when