Toshiba 13P KSG -T Manuale di installazione - Pagina 10

Sfoglia online o scarica il pdf Manuale di installazione per Condizionatore d'aria Toshiba 13P KSG -T. Toshiba 13P KSG -T 28.

Stampa la pagina

odel

Power source

Maximum running current

Circuit breaker rating

Power supply cable

Connecting cable

Wiring Connection

Indoor unit

irin o the connectin cable can be carried o t

ront anel.

1. Remove the air inlet grille.

Open the air inlet grille upward and pull it toward you.

2. Remove the terminal cover and cord clamp.

3. Insert the connecting cable (according to the local cords) into the pipe hole

on the wall.

4. Take out the connecting cable through the cable slot on the rear panel so

that it protrudes about 20 cm from the front.

5. Insert the connecting cable fully into the terminal block and secure it tightly

with screws.

6. Tightening torque : 1.2 N·m (0.12 kgf·m)

7. Secure the connecting cable with the cord clamp.

8. Fix the terminal cover, rear plate bushing and air inlet grille on the indoor

unit.

to install the air inlet rille on the indoor

nit

• When attaching the air inlet grille, the contrary of the removed operation is

performed.

TRI

50Hz, 220 V Single phase

5.0A

6.5A

H07RN-F or 60245 IEC66 (1.5 mm

itho t removin the

7.0A

9.0A

or more)

Outdoor unit

1. Remove the valve cover, the electric parts cover and the cord clamp from

the outdoor unit.

2. Connect the connecting cable to the terminal as identiﬁ ed by the

matching numbers on the terminal block of indoor and outdoor unit.

3. Insert the power cord and the connecting cable carefully into the terminal

block and secure it tightly with screws.

4. Use vinyl tape, etc. to insulate the cords which are not going to be used.

Locate them so that they do not touch any electrical or metal parts.

5. Secure the power cord and the connecting cable with the cord clamp.

6. Attach the electric parts cover and the valve cover on the outdoor unit.

Terminals block

Valve cover