Dimplex BLF3451 Manuale di servizio - Pagina 15

Sfoglia online o scarica il pdf Manuale di servizio per Camino da interno Dimplex BLF3451. Dimplex BLF3451 17.

may obstruct the ease of removing the Partially Reflective

Glass from the fireplace.

2. Remove the Partially Reflective Glass retaining brack-

ets by removing the 3 screws on each brackets; (3

brackets in total), located on the left and right side of

the Partially Reflective Glass. (Figure 14)

3. Remove the Partially Reflective Glass. Carefully place

the glass assembly aside in a safe location.

4. Remove the remaining screw, that secures the controls

assembly (Figure 9), located at the top of the mirror on

the right side of the unit.

5. Slide the controls assembly out toward the front of the

unit.

CAUTION: Ensure that the assembly is removed care-

fully, ensuring that no wires are caught or over strained.

6. Remove the heating cover by removing the 4 screws: 2

on the left and 2 on the right of the tray. (Figure 14)

7. Remove the 2 screws, that secure the controls assem-

bly (Figure 9), located at the top of the mirror on the

right side of the unit.

8. Slide the controls assembly out toward the front of the

unit.

CAUTION: Ensure that the assembly is removed care-

fully, ensuring that no wires are caught or over strained.

9. Remove the 2 screws, that secure the cover panel

(Figure 14), located at the top of the mirror on the left

side of the unit.

10. Remove the three screws on either side of the heater/

blower assembly and gently lower the assembly so that

the top can be viewed.

CAUTION: When removing the blower assembly

mounting screws, support the assembly to prevent any

damage to the unit.

11. Locate the thermistor, carefully cut the tie wrap attach-

ing the thermistor to the standoff.

12. Disconnect the wiring connections on the display /

control board.

13. Install the new thermistor and secure it with a new tie

wrap and connect all of the wiring connections.

14. Reassemble in the reverse order as above.