Dimplex BLF50 Manuale di servizio - Pagina 8

Sfoglia online o scarica il pdf Manuale di servizio per Camino da interno Dimplex BLF50. Dimplex BLF50 16.
Anche per Dimplex BLF50: Manuale di servizio (19 pagine)

Stampa la pagina

1. Exploded Parts Diagram

Recessed Mount - Partial In-wall

(FIGURE 8)

Tools Required: Philips head screwdriver – various lengths incl.

3" – 4" shaft.

CAUTION: Follow "Preparation for Service" instructions be-

fore proceeding.

Remove the 4 mounting screws located approximately 3

inches deep in the space between the outer and inner casing

on the left and right hand side. There are 2 screws per side,

upper and lower going into a stud. A Phillips head screw-

driver with a long shaft will be required. (FIGURE 9)

CAUTION: The fireplace should be supported while removing

the screws to prevent the unit from falling.

Remove the fireplace out of the opening by slightly lifting and

pulling forward.

Carefully lay the unit down on a solid flat surface with the

front of the unit facing up.

NOTE: If the surface you are using as a work area is a

finished surface that is prone to scratches (i.e. hardwood flooring),

it is recommended that a protective barrier be used underneath,

(i.e. cloth, cardboard, thick plastic).

Proceed to the instructions within this manual relating to the

repair being performed.

Once repair is complete, reassemble in the reverse order as

above.

Figure 8

Mounting Holes

Figure 9

Mounting Holes

Flush Mount – Complete In-wall

(FIGURE 10)

Tools Required: Philips head screwdriver – various lengths

CAUTION: Follow "Preparation for Service" instructions be-

fore proceeding.

Locate and remove the 4 mounting screws inside the unit

located on left and right side towards the front. There are 2

screws per side, going from the side panels out into the side

of the wall stud that frames the fireplace. (FIGURE 10)

CAUTION: The unit should be supported while removing the

screws to prevent the unit from falling.