Epson PowerLite 737c Informazioni sul prodotto - Pagina 10

Stampa la pagina

Epson PowerLite 737c Informazioni sul prodotto

Epson PowerLite 737c Projector

Starting the Projector with a Password

Note:

You must unplug the projector and then plug it back in to enable

password protection.

When the password function is enabled, you see this screen

when you plug in and turn on the projector:

Hold down the

button on the remote control as you use

Num

the numeric keypad buttons to enter the password. Once you

have entered the password correctly, the password screen closes,

and projection begins.

If the password is not correct, you see the message

password. Please try again

password three times in succession, you see the message

projector's operation will be locked. Request code xxxxx

and the projector switches to standby mode for approximately 5

minutes. Write down the request code. Then disconnect the

projector's power cord from the electrical outlet, reconnect it,

and turn the projector back on. When you see the Password

Protect Release screen, enter the correct password.

If you have forgotten the password, contact Epson for assistance

and give them the request code number that appears in the

Password Protect Release screen.

If you enter an incorrect password 30 times in a row, the

projector remains locked and you must contact an authorized

Epson servicer to unlock it.

Epson PowerLite 737c Projector

Wrong

. If you enter an incorrect

The

Disabling the Projector's Buttons

When you enable the Operation Lock function, all the

projector's buttons are disabled except the P

This is useful, for example, if you want to prevent students in a

classroom from playing with the projector.

1. Press the

button.

2. Select the

Setting

3. Select

Operation Lock

4. Select

and press

to confirm the setting.

5. Press the

button to exit the menu system.

Note:

You can cancel Operation Lock by pressing the projector's

button for 7 seconds.

Presenting Over a Wireless Network

Using EMP NS Connection, you can project images shown

on your computer screen directly to your audience without

connecting the projector to your computer. Before you begin,

make sure you've installed EMP NS Connection from the

CD-ROM that came with your projector. See the User's Guide

for installation instructions.

Starting EasyMP

Before you can connect to the projector wirelessly, you have to

switch it to EasyMP mode.

1. Turn on the remote control and the projector. Press the

button on the remote control to select EasyMP as

EasyMP

the source.

2. Locate the Epson 802.11 b/g card that came with your

projector. Insert it with the label facing upward.

Note:

Only the Epson 802.11 b/g card is guaranteed to work.

Other cards may not be compatible. Replacement cards are

available only through an Epson authorized servicer.

2/05

Power

menu and press

Enter

and press

Enter

. Then select

and press

Enter

Yes

™

button.

Enter