Epson PowerLite 83c Manuale informativo sul prodotto - Pagina 12

Sfoglia online o scarica il pdf Manuale informativo sul prodotto per Software Epson PowerLite 83c. Epson PowerLite 83c 16. Release of emp ns connection for windows & mac upgrade from v2.50 to v2.51
Anche per Epson PowerLite 83c: Manuale d'uso (42 pagine), Manuale operativo (36 pagine), Manuale operativo (47 pagine), Manuale di configurazione rapida (7 pagine), Manuale delle funzioni (5 pagine), Bollettino di assistenza prodotti (5 pagine), Bollettino di assistenza prodotti (25 pagine), Bollettino di assistenza prodotti (22 pagine), Elenco delle parti (1 pagine), Bollettino di assistenza prodotti (28 pagine), Dichiarazione di conformità (4 pagine), Bollettino di assistenza prodotti (41 pagine), Bollettino di assistenza prodotti (15 pagine), Bollettino di assistenza prodotti (22 pagine)

Stampa la pagina
Epson PowerLite 83c Manuale informativo sul prodotto
PowerLite 822p/83c Projector
You can remove the air filter to clean both sides.
If the dirt is difficult to remove or if the filter is torn, replace
it. Contact your dealer or call Epson at (800) 463-7766 to
obtain a new one (part number V13H134A13).
3. If you need to clean or replace the filter, slide it out, as
shown.
4. Align the new filter carefully and slide it in until it clicks
into place.
Note:
Air filters contain polycarbonate, ABS resin, and polyurethane
foam. Dispose of used air filters according to local regulations.
12
PowerLite 822p/83c Projector
-

Replacing the Lamp

The projection lamp typically lasts for about 3000 hours of use
(in high brightness mode) or 4000 hours (in low brightness
Vent
mode). It is time to replace the lamp when:
❏ The projected image gets darker or starts to deteriorate.
❏ The
❏ The message
when the lamp comes on. To maintain projector brightness
Air filter
and image quality, replace the lamp as soon as possible.
Note:
You can check to see how many hours the lamp has been used
through the Info menu.
Contact your dealer or call Epson at (800) 463-7766 for a
replacement lamp. Request part number V13H010L42.
Warning:
Let the lamp cool before replacing it. If the lamp breaks, handle the
shards carefully to avoid injury.
Follow these steps to replace the lamp:
1. Press the P
When you hear the projector beep twice, unplug the power
cord.
2. If the projector has been on, allow it to cool down for at
least an hour (or until the lamp is cool).
3. Use the screwdriver included with the replacement lamp (or
a #2 Phillips-head screwdriver) to loosen the screw holding
the lamp cover on top of the projector.
4. Slide the cover out, then lift it off.
3/08
lamp light is flashing orange.
appears on the screen
Replace the Lamp
button twice to turn off the projector.
Power