Epson PowerLite 85 Manuale di configurazione rapida - Pagina 6

Network configuration

If you need to configure the projector for your network, you can use the

projector's menu system.

Press the Menu button on the remote control, select the Network menu,

then press Enter.

Choose Network Configuration and press Enter.

Select the Wired LAN menu and press Enter.

Choose IP Settings and press Enter. You see a screen like the following:

Do one of the following:

•

If your network assigns addresses automatically, turn on the DHCP

setting.

•

If your network does not assign addresses automatically, turn

off DHCP and enter the projector's IP Address, Subnet Mask, and

Gateway Address, as needed.

To enter numbers, use the

highlight the number you want to input, then press the Enter button.

When you're finished entering an address in the network menu, highlight

Return, then press the Enter button.

To prevent the IP address from appearing on the standby screen, set the

IP Address Display setting to Off.

When you're done making all necessary changes, select Complete and

press the Enter button to save your settings. Then press Enter again to

confirm.

Press the Menu button to exit the menu system.

buttons on the remote control to