Epson Stylus Pro 10000 Series Manuale di riferimento rapido - Pagina 5

Sfoglia online o scarica il pdf Manuale di riferimento rapido per Software Epson Stylus Pro 10000 Series. Epson Stylus Pro 10000 Series 12. Auto take-up reel unit
Anche per Epson Stylus Pro 10000 Series: Specifiche tecniche (6 pagine), Informazioni sul prodotto (16 pagine), Manuale di installazione (26 pagine), Manuale di installazione rapida (34 pagine), Garanzia (28 pagine), Manuale di riferimento rapido (12 pagine), Specifiche tecniche (4 pagine), Specifiche tecniche (1 pagine), Manuale di montaggio (12 pagine), Manuale d'uso (13 pagine)

Stampa la pagina
Epson Stylus Pro 10000 Series Manuale di riferimento rapido

Checking and Cleaning the Print Head

Checking and Cleaning the Print Head
First you print a nozzle check pattern to see if the print
head needs cleaning. If dots are missing from the pattern,
you need to run a cleaning cycle. After cleaning, run
another nozzle check.
1
Load a sheet of paper (or roll paper) in the printer.
2
Press the
SelecType
appears on the display.

PRINT MENU

3
Press the
button.
Item
appears on the display.
4
Press the
button. The nozzle check prints as
Enter
shown below:
If all the lines on the check pattern are complete, with
no gaps in the dot pattern, the print head doesn't need
cleaning.
button repeatedly until
®
TEST
NOZZLE CHECK = PRINT
If dots are missing from the pattern, as shown below,
you need to run a cleaning cycle.
5
Make sure that all of the
printer's control panel are off. If an
flashing or on, you need to replace the corresponding
ink cartridge instead.
6
Press the
Cleaning
3 seconds. The
Pause
cleans its print head. The cleaning cycle takes about
a minute and does not use any paper.
To avoid damaging the printer, don't turn it off
until the cleaning cycle is finished and the
Pause light has stopped flashing.
7
When the
Pause
4 to run another nozzle check to make sure the print
head is clean.
4
lights on the
Ink Out
light is
Ink Out
button and hold it for at least
light flashes as the printer
light goes off, follow steps 1 through