Before switching on the television put your decoder and media recorder to Standby if they are connected
and ensure the aerial is connected to your television. To set up the television use the buttons on the remote
IMPORTANT: Ensure that the aerial is connected and
a Common Interface module is not inserted before
switching on the TV for the fi rst time installation.
1.
Connect the mains plug and switch the TV
using the side standby switch. If the TV does not
switch on, press any numbered or
the remote control, then the language selection
menu will be displayed. This screen will appear
the fi rst time that the TV is switched on and each
time the TV is reset.
2.
By pressing
Up or Down button, highlight the
language you want to set and press OK button.
The following message will be displayed next:
3.
By pressing
Left or Right button, select the
country you want to set and press Down button
to highlight Teletext Language option. Use
Left or Right button to select desired Teletext
Language.
4.
Press
Down button after setting Teletext Language
option. Scan Encrypted will be then highlighted.
You can set Scan Encrypted as Yes if you want
to scan coded stations.
5.
Press
OK button on the remote control to continue
and the following message will be displayed on
the screen:
32BV501B_MB60_[GB]_(IB_INTERNET)_DVB-T_(3910uk)_10072937_10074859.indd 20
32BV501B_MB60_[GB]_(IB_INTERNET)_DVB-T_(3910uk)_10072937_10074859.indd 20
Initial Installation
control as detailed on page 13.
to on
button on
6.
Select
and press OK button to continue.
7.
The Auto tuning screen will appear and the
television will start to search for available stations.
The progress bar will move along the line. You
must allow the television to complete the search.
The following OSD will be displayed on the
screen and the television will search for digital
and analogue TV broadcasts:
Note: You can press MENU button to cancel.
•
After the available stations are stored, Channel List
will be displayed on the screen. If you like the sort
channels, according to the LCN, please select Yes
and then press OK button (if available).
•
Press
OK button to quit channel list and watch TV.
Note:
Do not turn off the TV while initializing fi rst time
installation.
- 20 -
Yes button by using Left or Right button
03.10.2011 18:46:04
03.10.2011 18:46:04
Stampa la pagina