A wide variety of external equipment can be connected via the sockets located on the side and back of the
television. Whilst all the necessary adjustments and controls for the television are made using the remote
control, the buttons on the left side of the television may be used for some functions.
Switching on
If the standby LED is unlit, check that the mains plug is con-
nected to the power and press the
of the television to switch the television on.
To put the television into Standby, press
remote control or on the TV. To view the television, press
button again. The picture may take a few seconds to
appear.
Note: The active Standby LED may appear for a few moments
when the TV is switched off.
For energy saving:
Turning the television off at its mains supply, or un-plugging
it, will cut energy use to nearly zero for all televisions. This
is recommended when the television is not being used for a
long time, e.g. when on holiday.
Reducing the brightness of the screen will reduce energy use.
Energy effi ciency cuts energy consumption and thus saves
money by reducing electricity bills.
NOTE: Putting the television into standby mode, will reduce
energy consumption, but will still draw some power.
40BL702B_MB65_[GB]_(IB_INTERNET)_DVB-T_(3910UK)_10075901.indd 18
40BL702B_MB65_[GB]_(IB_INTERNET)_DVB-T_(3910UK)_10075901.indd 18
Controlling the TV
Press the MENU button on the remote control to see the
menus.
button on the right side
The main menu appears as a group of icons each for a menu
option. Press the Left or Right button to select a topic.
button on the
In sub menu screen mode the menu appears as a list. Press
the Up or Down button to select a topic.
To use the options press the Up and Down buttons on the
remote control to move up and down through them and OK,
Left or Right buttons to select the required choice. Follow
the on screen instructions. The functions of each menu are
described in detail throughout the manual.
Using the Controls and Connections on the TV
Using the control buttons on the front of the TV:
• To alter the volume press +
• To alter the programme position press
side of the TV.
• Press +
use
To select an external input, press SOURCE until the appropri-
ate input source is selected.
Please always refer to the owner's manual of the equipment
to be connected for full details.
- 18 -
Using the Remote Control
-.
- buttons at the same to view main menu and
to navigate and +
- to change value.
on the right
21.01.2012 18:06:21
21.01.2012 18:06:21
Stampa la pagina