Philips 3 CD CHANGER WITH DOLBY PRO LOGIC PROCESSOR FWP88C Manuale d'uso - Pagina 31
Sfoglia online o scarica il pdf Manuale d'uso per Impianto stereo Philips 3 CD CHANGER WITH DOLBY PRO LOGIC PROCESSOR FWP88C. Philips 3 CD CHANGER WITH DOLBY PRO LOGIC PROCESSOR FWP88C 31. 3 cd changer with dolby® pro logic processor, five loudspeakers, 320 watts total power
Anche per Philips 3 CD CHANGER WITH DOLBY PRO LOGIC PROCESSOR FWP88C: Specifiche tecniche (2 pagine), Manuale (31 pagine)
Stampa la pagina
Tape Deck Operation
Recording or playback cannot be
made or there is a decrease in audio
level.
• Dirty tape heads, capstans or pressure
rollers.
™ See section on tape deck maintenance
(page 30).
• Magnetic build-up in the record/
playback head.
™ Use demagnetizing tape.
Tape deck door cannot open.
• Power failure or AC power plug
disconnect from the wall outlet during
tape playback.
™ Reconnect the AC power plug and
switch on the system again.
Recorded material sounds strange.
• Tape was recorded in one of the Dolby
Pro Logic modes.
™ Switch off Dolby Pro Logic mode when
recording.
pg 01-31/P88/22-Eng
31
General
System does not react when any
button is pressed.
• Electrostatic discharge.
™ Press STANDBY ON to switch the
system off. Remove the AC power plug
from the wall outlet, then reconnect the
power plug and switch on the system
again.
No or poor sound.
• Volume is not turned up.
™ Adjust VOLUME.
• The headphones are connected.
™ Disconnect the headphones.
• Speakers are not connected or are
connected wrongly.
™ Check that the speakers are connected
correctly.
™ Make sure the stripped speaker wire is
clamped.
Reversed left and right sound.
• Speakers are connected wrongly.
™ Check the speaker connections and
location.
Lack of bass sound or apparently
imprecise physical location of musical
instruments.
• Speakers are connected wrongly.
™ Check the speaker connection for
proper phasing, colored/black wires to
colored/black terminals.
Remote control has no effect on the
system.
• Wrong source is selected.
™ Select the source (CD, TUNER, etc.)
before pressing the function button
( É , í , ë , etc.).
• The distance to the system is too large.
™ Reduce the distance.
• Batteries are inserted incorrectly.
™ Insert the batteries with their polarities
(+/– signs) as indicated.
• Batteries are exhausted.
™ Replace the batteries.
Timer is not working.
• Clock is not set.
™ Set the clock.
• Timer is not switched on.
™ Press TIMER ON/OFF to switch on the
timer.
• Recording is in progress.
™ Stop recording.
Clock setting is erased.
• There was a power failure.
™ Reset the clock.
System displays features
automatically; buttons flash
continuously.
• Demonstration mode is switched on.
™ Press and hold Ç (on the system) for 5
seconds to switch off the
demonstration.
3/6/00, 1:28 PM
TROUBLESHOOTING
There is a howling sound at the
external source.
• You hear feedback when you are
listening in AUX mode.
™ Press AUX to select CDR/DVD mode.
All lighted buttons are not lit.
• Display is switch on in DIM 3 mode.
™ Press DIM until DIM OFF display mode
is shown.
3139 116 19721
31