Toshiba MJ-1101 Addendum al manuale di servizio - Pagina 3
Sfoglia online o scarica il pdf Addendum al manuale di servizio per Stampante All in One Toshiba MJ-1101. Toshiba MJ-1101 17. Supplement to the troubleshooting section
Stampa la pagina
Error code
Phenomenon
Possible cause
EA20
- Paper jams at the
1. Improper installation height
entrance section of
the Finisher (or the
(Paper is not properly transported
Hole Punch Unit)
from the equipment to the
Finisher if each height is
- Folded paper edge
improper.)
- Paper jams C2in the
buffer tray section
- C2Paper exit
problems on the
finishing tray
2. Bridge Unit exit Mylar deformed
Items to confirm / Countermeasures
A. Confirm that the Finisher is installed horizontally (the height of its front side and that of its rear side are the
same).
The length of the arrows should be the same.
B. To keep the installation height of the Finisher stable, it is preferable that the casters are faced to the equipment
side.
Caster
quipment side
C. When installing the Finisher in the equipment, make sure that the height of the Finisher is proper. If it is not, the
Bridge Unit exit Mylar may be deformed, and thus the deformed Mylar may obstruct the paper transport path.
Check if the Mylar attached to the exit of the Bridge Unit is deformed and obstructing the paper transport path.
Correct it if deformed.
Normal
Improper
case
Installation height
Abnormal
Deformed Mylar
Paper transport path
Precautions / Remarks
- Note that the height should be different between the cases when the Finisher
is installed in e-STUDIO281c/351c/451c and when installed in e-
STUDIO352/452 or e-STUDIO2500c/3500c/3510c.
- Confirm the height every time you move the equipment.
Note that the height should be different between the cases when the Finisher
is installed in e-STUDIO281c/351c/451c and when installed in e-
STUDIO352/452 or e-STUDIO2500c/3500c/3510c.