Toshiba TDP-XP2U - XGA DLP Projector Manuale d'uso - Pagina 37
Sfoglia online o scarica il pdf Manuale d'uso per Proiettore Toshiba TDP-XP2U - XGA DLP Projector. Toshiba TDP-XP2U - XGA DLP Projector 48. Tdp-xp1u user's guide
Stampa la pagina
Lamp replacement
A lamp is consumable supply. If used for extended periods, images will appear dark, and the
lamp could burn out. This is characteristic of a lamp, and is not malfunction. (The lifetime of
the lamp depends on condition of use.) If this happens, replace it with a new one.
WARNING
• If the projector is mounted on the ceiling, it is recommended to use your Toshiba dealer-
ship when the lamp has to be exchanged.
Uncovering the lamp while the projector is mounted on a ceiling may lead to a danger
of damage from falling pieces of glass if the lamp is broken. Besides, working at high
elevations can also be hazardous. Do not attempt to replace the lamp by yourself.
• When replacing, always use lamp "TLPLV10" (sold separately). If the lamp other
than the specified one is used, it may cause a malfunction or damage to the unit due
to the difference in the connector shape or the lamp rate.
CAUTION
• If you have been using the projector, the lamp will be very hot, and may cause burn
injuries.
Wait for the lamp to cool (for longer than 1 hour) before replacing it.
• If the lamp should break, please handle with care to avoid injury due to broken
pieces and contact your dealer for repair service.
1
Unplug power cord.
2
Wait until lamp is sufficiently cooled.
Wait for at least 1 hour.
3
Remove the lamp cover.
Loosen the two screws, raise the lamp cover
with your fingers as shown to remove the lamp
cover. Use care to avoid any damage to nails
and/or tip of your finger(s). If you have any dif-
ficulty in removal, you can use a screwdriver or
any other smaller tool for your convenience.
4
Pull out the lamp.
Loosen the two screws holding the lamp in place,
and pull up the handle to remove the lamp.
3
4
37
Lamp cover
1
2
1
2