Croydex AP501122 Manuale di avvio rapido

Sfoglia online o scarica il pdf Manuale di avvio rapido per Aiuto per il bagno Croydex AP501122. Croydex AP501122 2.

Thank you for purchasing this Croydex product. Please follow the fixing and care

instructions to ensure your grab bar is fitted safely and it retains its high quality finish.

Fittings instruction for the following products:

AP5010** - 300mm Stainless Steel Grab Bar with Concealed Fixings

AP5011** - 450mm Stainless Steel Grab Bar with Concealed Fixings

AP5012** - 600mm Stainless Steel Grab Bar with Concealed Fixings

AP5013** - Angled Stainless Steel Grab Bar with Concealed Fixings

AP500541 - 300mm Stainless Steel Grab Bar with Anti-Slip Grip

AP500741 - 600mm Stainless Steel Grab Bar with Anti-Slip Grip

Tools Required

Pencil, Drill, Masonry drill bit appropriate to fixings, Ceramic drill bit (optional) appropriate

to fixings, Spirit Level, Screwdriver appropriate to fixings.

Please ensure that suitable fixings are purchased that are compatible with wall

construction materials

KEEP DIY TOOLS OUT OF THE REACH OF CHILDREN

Safety and Care Advice

1. It is recommended that two people fit this product to ensure that it is fitted safely.

2. Always take care when using power tools, particularly in the bathroom.

3. Always check for hidden cables and pipework before drilling and take extreme care

if there is any water in the working area.

4. It is advisable to use a residual current circuit breaker (RCCB) when using mains

powered tools.

5. Always wear suitable eye protection when drilling.

6. If the product is to be fitted on a ceramic tiled wall, a ceramic drill bit should be

used.

7. Always ensure that the drill hole passes through the central tiled area rather than

through the grouted area. To prevent damage to the tile, mask the area around the

hole with tape before drilling.

8. Do not strike the product with hard or sharp objects.

Product Location

Grab and support bars are only as strong as the wall to which they are fixed and the

fixings that are used.

For different wall types you will need to ensure that you are using the correct type of fixing

for the material of the wall.

The addition of backboards on the outside of the wall or appropriate strengthening of

internal structures may be required to provide adequate wall strength.

If the wall is made of lightweight thermal blocks, aerated hollow brickwork or

prefabricated partitions even the most appropriate fixings may not be able to

withstand the loads which can be suddenly applied to grab bars, hinged support

bars and seats.

S&H 022 R02