CRU DataPort 25 Manuale di avvio rapido - Pagina 2

Sfoglia online o scarica il pdf Manuale di avvio rapido per Immagazzinamento CRU DataPort 25. CRU DataPort 25 2. Usb 3.0 carrier

Stampa la pagina

1 Installation Steps

1.1 Floppy Bay Frame Installation

a. Slide the receiving frame into an open 3.5" Floppy Drive bay.

b. Secure the receiving frame to the chassis with the mounting screws provided.

c. Attach a SATA data cable to the SATA connector on the rear of the frame

and attach the other end to the appropriate SATA port on the computer's

motherboard. Port JP4 connects to the bottom hard drive in the carrier and

JP5 connects to the top hard drive. For SAS, JP4 is the primary channel and

JP5 is the secondary.

d. Attach a 4-pin Floppy power cable to the power connector on the rear of the

Floppy Drive bay. The frame requires both +12VDC and +5VDC to operate.

Most floppy connectors fulfill this requirement.

1.2 Hard Drive Installation

a. If the carrier is bundled with a frame, press the Eject button once to release

the button, and again to eject the carrier from the frame. If the lock is engaged

and the eject button will not release the carrier, insert the provided Dataport

Key into the frame and turn it 90 degrees counterclockwise to release the

lock so that you can eject the carrier.

b. Slide the cover of the carrier back and off.

c. Remove the screw kit from the carrier.

d. Insert a 2.5" SATA drive with the top label facing down into the unified power

and data connector inside the carrier.

e. Secure the hard drive to the carrier by using the mounting screws provided.

f. Replace the cover and secure it by inserting two screws from the screw kit

into the rear of the carrier.

1.3 Operating Your DataPort 25 in a Floppy Bay Frame

a. Slide the DataPort 25 carrier into the frame.

b. Insert the provided key into the keylock and turn it 90 degrees clockwise to

secure the carrier into the frame and power it on.

When any hard drive is first used with the DataPort 25 it will show up as a blank,

unallocated drive and you'll need to format the drive inside the enclosure before

you can use it. Note that formatting a drive will erase all data on the

drive, so be sure to back up your data before beginning this operation.

1.4 Operating Your DataPort 25 with USB 3

a. Insert a USB 2.0 or USB 3.0 cable into the front of the DP25 and connect

the other end to your computer. When using a USB 2.0 cable you will be

limited to the USB 2.0 transfer speed of up to 480Mbps, and you may have

to use the provided power supply to power the unit. If you are operating

on USB 3.0 with bus power, the drive will power up automatically and be

detected by your computer.

NOTE: Do not operate the DP25 in a DP25 Floppy Bay Frame while

using USB 3.0.

b. If you are not able to operate on bus power, plug the DataPort 25 into AC

power using the provided power plug. The drive should then power up and

be detected by your computer.

When any hard drive is first used with the DataPort 25 it will show up as a blank,

unallocated drive and you'll need to format the drive inside the enclosure before

you can use it. Note that formatting a drive will erase all data on the

drive, so be sure to back up your data before beginning this operation.

CRU Mark

10.25.12

PMS 711

2 cyan

85 magenta

76 yellow