Cruise control AP900Ci Manuale di installazione rapida - Pagina 8
Sfoglia online o scarica il pdf Manuale di installazione rapida per Automobile Accessories Cruise control AP900Ci. Cruise control AP900Ci 11.
Stampa la pagina8
ACTIVATING ANALOG MODE
Perform only if CAN signals not available!
When analog mode activated must analog wires be connected according chapter 9.
Press and hold SW1 of
central unit and
switch ignition ON
In analog mode must in addition to T-harness be connected following wires:
ORANGE
ignition (+12V when ignition switched ON)
BLUE
vehicle speed pulse (ground pulses which frequency depends of vehicle speed)
BROWN
hot side of brake switch (+12V always or when ignition ON)
BROWN/WHITE cold side of brake switch (+12V when brake pedal pressed)
VIOLET
clutch switch wire whree state of ground will change when pedal is pressed (usually grounded when
pedal is peressed but is working also when grounded when pedal is not pressed).
Main diagram on chapter 9
When all wires are connected must be performed following setup steps:
Chapter 3:
Pedal learning
Chapter 10:
Learning of speed signal
Optionally can be performed chapter 4 diagnostic and chapter 5 and 6: init and gain adjustment.
If speed limiter is in analog mode but it's needed to activate CAN mode just perform CAN search according chapter 7.
When CAN software will be found turns limiter to CAN mode and starts to work without performing "Software unlock".
AP900Ci/ GC90Ci quick installation manual
ON
HIGH
Switch speed limiter ON -
2 beeps, release SW1
2x
RES x 1
Press RES key once
(CM down):
4 short beeps
4x
HIGH
ANALOG MODE
IS ACTIVATED
ProTeam OÜ