Cruise N Comfort MES 24 Manuale di installazione e istruzioni per l'uso - Pagina 2
Sfoglia online o scarica il pdf Manuale di installazione e istruzioni per l'uso per Condizionatore d'aria Cruise N Comfort MES 24. Cruise N Comfort MES 24 7. 12volt marine air conditioners
Stampa la pagina7. Connect the 1/2" hose from the water pump to the "water in" on the
A/C unit and double clamp each end. fig.7
8. Connect a 1/2 in. hose from the thru-hull water dump fitting to the
"water out" fitting on the A/C unit and double clamp each end. fig.
7
9. Run the primary power wires from the A/C unit to the battery. Install
a 60 amp marine grade explosion proof fuse and holder to the
positive battery terminal.
10. Connect A/C Control unit. fig.8
11. Connect the power and ground connections to the unit fig.8 (make
sure the power switch is in the off position). Do not remove the
compressors power ring terminals that are already installed. Tighten
securely.
12. Connect the main power negative (-)wire (4 gauge) to the battery
using ring terminal *.
13. Connect the main power positive (+) wire (4 gauge) to the fuse that
you connected to the battery.
*Note: holder, 4 gauge wire and ring terminal not provided
14. Connect 4" insulated vent hose to unit no longer than 6 feet and
run hose to area that is to be cooled. Remember for best results
aim the vent toward the person to be cooled. Mount vent or ducting
assembly and connect hose be sure to use non conductive hose
with a non conductive fastener. For best results, make sure that air
from the cooled area can be returned with ease to the A/C air inlet
on the front of the unit. The best way of doing this is to mount the
unit in the area that is being cooled . By recycling cool air, unit
will provide coldest air possible. Do not mount this unit in engine
area or where exhaust and gas fumes can be exposed to this unit.
Page
2
of
7