Dimplex DS4411 Manuale di servizio - Pagina 8

Sfoglia online o scarica il pdf Manuale di servizio per Stufa Dimplex DS4411. Dimplex DS4411 11. Compact stove
Anche per Dimplex DS4411: Manuale d'uso (13 pagine), Manuale d'uso (12 pagine), Manuale d'uso (15 pagine), Manuale di risoluzione dei problemi (4 pagine)

Stampa la pagina
Dimplex DS4411 Manuale di servizio
Switch Replacement - Units with
Thermostat
WARNINg: If the stove was operating prior to servic-
ing, allow at least 10 minutes for light bulbs and heating
elements to cool off to avoid accidental burning of skin.
WARNINg: Disconnect power before attempting any
maintenance to reduce the risk of electric shock or damage
to persons.
1.
Remove (8) screws from top panel and set aside.
2.
Locate the defective switch mounted on the back panel
and disconnect the wiring clips and connections noting
their original locations.
3.
Depress the retainer clips on the rear of the switch and
push the switch out of the back panel.
4.
Properly orient the new switch and connect all of the
wiring clips and connections.
5.
Reassemble in the reverse order as above.

Thermostat Control Replacement

WARNINg: If the stove was operating prior to servic-
ing, allow at least 10 minutes for light bulbs and heating
elements to cool off to avoid accidental burning of skin.
WARNINg: Disconnect power before attempting any
maintenance to reduce the risk of electric shock or damage
to persons.
1.
Remove (8) screws from top panel and set aside.
2.
Remove thermostat knob.
3.
Remove (2) thermostat screws from back panel.
4.
Remove thermostat connections noting their original
locations.
5.
Install supplied thermostat.
6.
Reassemble in reverse order as above.
Switch Replacement - Units without
Thermostat
1.
Lay unit on side.
2.
Remove 4 legs – 3 screws per leg. (Figure 5)
3.
Remove 4 screws from bottom panel to allow bottom of
stove to open – 1 on each side of bottom panel and 2
on front of bottom panel. (Figure 5)
4.
Insert hand through bottom of stove and push tabs on
switch that is needed to be replaced.
5.
While pushing on the tabs on the switch, slowly push
the switch out of its location hole.
6.
Disconnect attached wires from switch.
7.
Pick up new switch and install wires to terminals on
switch – ensure wires are attached to same terminals
as prior switch – see Figure 6 for wire colours.
8.
Insert switch through location hole and snap in place.
9.
Reassemble in the reverse order as above.
8
Figure 5
Screws for Legs
Figure 6
High
Heat
3
1
2
Wire Number
1
2
3
4
Screws to Remove
the Bottom Panel
Main
Low
On/Off
Heat
2
Wire Colour
Yellow
Red
Grey
White
www.dimplex.com
2
4
4