3Com HomeConnect 3CP3617B Manuale di installazione

Sfoglia online o scarica il pdf Manuale di installazione per Modem 3Com HomeConnect 3CP3617B. 3Com HomeConnect 3CP3617B 8. 3com homeconnect 3cp3617b modems: installation guide

Stampa la pagina

Installation Guide

Starting The Installation

WARNING: Windows NT users must install the PCI card before installing the software. If you are

running Windows NT, do not proceed until you have installed the PCI Card in an available PCI slot.

If you are running Windows 95/98/Me/2000 you must install the software before installing the PCI

card. To begin the software installation, place the 3Com HomeConnect ADSL PCI Installation

CD-ROM in the CD-ROM drive. The setup program should automatically start. The software

interview for all operating systems has the same look as the screen below. If the installation does

not launch automatically, click Start, Run, and then type d:\setup.exe, where d stands for the

letter of the CD-ROM drive.

Upon seeing this screen, click Next.

Installing Dial-up Networking

xIn Windows 95, 98 and Me, if the Dial-up Networking function hasn't already been installed on

your computer, you will be prompted to install it. The prompts will look a little different in each

operating system.

In Windows 95, the first screen will ask if you want to install Dial-up Networking. Click to

accept and you will see a screen similar to the screen used in Windows 98 and Me,

which allows you to initiate the Windows procedure to complete the installation. Click

Finish. Windows 95 will install Dial-up Networking. Windows 98 or Me will launch the

"Windows Add/Remove Programs" applet. Select the Windows Setup tab, then double

click the word Communications. This will open the "Communications" screen.

CAUTION: Do not remove the check mark next to the word "Communications" and do not click

OK.

In the "Communications" screen, check the Dial-up Networking box by clicking to the left

of the "Dial-up Networking" icon, then click OK. Click Apply, then click OK when the

message reminding you to reboot appears. Finally, click OK to exit. Reboot in order to

establish the correct entries in the Windows registry. If the program doesn't resume

automatically, just reinsert your CD-ROM and the install procedure will recommence. You

will find that the Dial-up Networking capability has been installed.