Crux SOOGM-16V Manuale - Pagina 4

Sfoglia online o scarica il pdf Manuale per Apparecchiature di registrazione Crux SOOGM-16V. Crux SOOGM-16V 5.

The SOOGM-16V can force the aftermarket radio to show the front

GM trucks and SUV's with power mirror controls at any time while driving. To force the front or rear

camera while driving do the following...

1. Set the power mirror selection to off (both LED lights must be off on the power mirror switch).

You can turn off the LED by pressing the button on the same side that the LED is currently lit.

Note: Turning off the mirror selection will prevent the mirrors from being adjusted while forcing

the front/rear camera mode.

2. To force the Front camera mode, press and hold the Up arrow on

the 4-way joystick until the video shows on the aftermarket radio.

3. To force the Rear camera mode, press and hold the Down arrow on

the 4-way joystick until the video shows on the aftermarket radio.

(If the vehicle is not equipped with a factory backup camera, an

aftermarket backup camera can be installed and plugged into the

SOOGM-15 backup camera video harness)

4. To turn Off forced camera mode, press and hold the 4-way joystick

Up arrow if in front camera mode or Down arrow if in rear camera

mode. Wait until the video turns off on the aftermarket radio then release the 4-way joystick.

5. The reverse camera has priority over the front camera when driving the vehicle in reverse.

(Requires installation of aftermarket camera)

To retain the use of the IR headphones with the factory overhead entertainment system you will

need to connect a +12 volt switched accessory power wire to the rear entertainment panel wire

harness located in the rear of the center console. You will need a 1 amp fuse and a 1N4001 diode

to complete the installation. Remove the RSE control panel in the center console. Tools will be

required such as a panel remover tool and/or 7mm socket. Locate the (pink) wire located in pin 14

of the (gray) connector. Connect the diode's stripe side to the pink wire. Connect the other end of

the diode to one side of the 1 amp fuse. Connect the remaining side of the fuse to a +12 switched

accessory wire. Refer to the wiring diagram below.

or rear video camera on select

4 / 5

rev071217