Dimplex DCPF50MB Manuale di istruzioni - Pagina 7

Sfoglia online o scarica il pdf Manuale di istruzioni per Ventilatore Dimplex DCPF50MB. Dimplex DCPF50MB 10. Hv pedestal fan
Anche per Dimplex DCPF50MB: Manuale di istruzioni (6 pagine)

Stampa la pagina

Assembly

1. Assemble the base (14) to the adjustable pipe (12) by holding the base on it's

side, and inserting the pipe into the centre. Secure the pipe (12) to the base (14)

with the supplied 19mm bolt & washer (15). Firmly tighten with a 19mm spanner

(not supplied).

2. To assemble the fan motor (8) to the adjustable pipe (12) locate the motor fixing

hole (10) and align with the adjustable pipe fixing hole (11). To secure the fan

motor to the adjustable pipe, use the long bolt & washer (supplied) and push

through the hole. Tighten the bolt well.

3. Align the rear grille (5) to motor shaft (6) on the fan motor (8) and ensure the

hole for the safety screw is at the bottom. The 4 screw holes on the front of the

fan motor (8) should line up. Firmly tighten all four rear grille screws (4).

4. Once the rear grille (5) is attached to the fan motor (8), turn the motor shaft

(6) so the flat area is at the top. Slide the fan blade (3) all the way onto the

motor shaft (6) and firmly tighten the grub screw (2) by rotating in a clockwise

direction.

5. Once the fan blade is fixed, align the top locking clip on the front grille (1) so it

fixes to the that of the rear grille (5). Lock the side and bottom clips in place.

TIP: the logo should be horizontal. Secure the front & rear grille, by inserting and

fixing the safety screw (16) and nut.

Operation

1. Ensure the rotary switch (9) is in the '0' position, prior to connecting the plug to

the power supply.

2. Switch the fan ON by rotating the rotary switch (9) on the back of the fan motor

(8) to the desired setting - 1, 2 or 3. Turn to the '0' position to turn OFF.

3. To start oscillation, press the oscillation On/Off switch (7) to the 'I' position. To

turn oscillation off, press to 'O' position.

4. The airflow direction can be adjusted upward/downward by lifting up or pressing

down the motor housing.

NOTE: Only adjust the fan head when the unit is OFF. Be careful not to insert your

fingers through the guard.