Pioneer DEH-4200SD Manuale operativo - Pagina 18

Sfoglia online o scarica il pdf Manuale operativo per Ricevitore per auto Pioneer DEH-4200SD. Pioneer DEH-4200SD 28. Cd rds receiver
Anche per Pioneer DEH-4200SD: Manuale operativo (29 pagine), Manuale di installazione (8 pagine)

Stampa la pagina

Operating this unit

Initial Settings

Important

Power save mode is cancelled if the vehicle battery is disconnected and will need to

be turned back on once the battery is reconnected. When power save is off, depending

on connection methods, the unit may continue to draw power from the battery if your

vehicle's ignition switch doesn't have an ACC (accessory position).

1. Press SRC/OFF and hold until the unit turns off.

2. Press SRC/OFF and hold until the initial setting menu appears in the display.

3. Turn M.C. to select the initial setting.

After selecting, perform the following procedures to set the initial setting.

FM step (FM tuning step)

Normally the FM tuning step employed by seek tuning is 50 kHz. When AF or TA is on,

the tuning step automatically changes to 100 kHz. It may be preferable to set the

tuning step to 50 kHz when AF is on.

1. Press M.C. to display the setting mode.

2. Turn M.C. to select the FM tuning step.

100kHz (100 kHz) – 50kHz (50 kHz)

3. Press M.C. to confirm the selection.

Auto PI (auto PI seek)

The unit can automatically search for a different station with the same programming,

even during preset recall.

* Press M.C. to turn Auto PI seek on or off.

AUX (auxiliary input)

Activate this setting when using auxiliary device connected to this unit.

* Press M.C. to turn AUX on or off.

USB PnP (plug and play)

This setting allows you to switch your source to USB/USB-iPod automatically.

* Press M.C. to turn the plug and play on or off.

ON – When USB storage device/iPod is connected, the source is automatically

switched to USB/USB-iPod. If you disconnect your USB storage device/iPod, this

unit's source is turned off.

OFF – When USB storage device/iPod is connected, the source is not switched to

USB/USB-iPod automatically. Please change the source to USB/USB-iPod

manually.

Brightness (display brightness setting)

1. Press M.C. to display the setting mode.

2. Turn M.C. to switch the brightness setting.

High (high) – Low (low)

3. Press M.C. to confirm the selection.

SW control (rear output and subwoofer setting)

Only for DEH-4200SD.

This unit's rear output (rear speaker leads output) can be used for full-range speaker

(Full) or subwoofer (SUBW) connection. If you switch the rear output setting to SUBW,

you can connect a rear speaker lead directly to a subwoofer without using an auxiliary

amp.

1. Press M.C. to display the setting mode.

2. Turn M.C. to change the setting.

Rear SP: Full – SUBW

3. Press M.C. to confirm the selection.

Only for DEH-3200UB.

The rear speaker leads output (Rear SP) and RCA output (Preout) of DEH-3200UB

can be used for full-range speaker (Rear SP :Full/Preout :Rear) or subwoofer (Rear

SP :SUBW/Preout :SUBW) connection. If you switch to Rear SP :SUBW, you can

connect a rear speaker lead directly to a subwoofer without using an auxiliary amp.