Pioneer DCS-333 Impostazione

Sfoglia online o scarica il pdf Impostazione per Ricevitore Pioneer DCS-333. Pioneer DCS-333 2. Dvd/cd receiver

Setting up your DVD/CD Receiver

When connecting this system or changing connections, be sure to switch the power off with the STANDBY/ON button, and disconnect the power cord from the AC outlet.

Do not use these speakers with any other system or amplifier as this may result in damage or fire.

Check that you have all the accessories, then put

the batteries in the remote control.

Batteries and

remote control

Power cord *

STANDBY/ON

* In some countries or regions, the shape of the

FM/AM

L1/L2

DVD

TUNER

LINE

power plug may sometimes differ from that

FRONT

SURROUND

OPEN CLOSE

shown in the explanatory drawings.

DVD MENU

RETURN

TUNE+

ST–

ST+

ENTER

BASS

MUTE

TUNE–

MODE

Video cord

MASTER

VOLUME

TV CONTROL

INPUT

VOL

OPEN

FM antenna

AM loop antenna

Microphone

(for Auto MCACC setup)

Connect each speaker using the color-coded

speaker cords. Match them to the colored

speaker terminals on the rear panel of the

DVD/CD receiver.

* Illustration shows the European model

MCACC

MIC

FRONT

CENTER

SPEAKERS

SURROUND

SUB

WOOFER

For the best surround sound, setup your speakers as

above. The front left and right speakers should be

about 1.8–2.7 m (6–9 ft) apart.

These speaker terminals can be hazardous when live. When you connect or

disconnect the speaker cables, to prevent the risk of electric shock, do not

touch uninsulated parts before disconnecting the power cord.

Speaker Setup Guide

What's in the box

• Front speakers x 2

• Front speaker stand bases

• Center speaker x 1

x 2

• Surround speakers x 2

• Screws (for bases) x 6

• Subwoofer x 1

• Brackets x 2

• Speaker cords:

• Screws (for brackets) x 4

Red/White (Front speakers)

• Mounting brackets x 2

4 m x 2

• Screws

Green (Center speaker) 4 m x 1

(for mounting brackets) x 2

Blue/Grey (Surround speakers)

10m x 2

Purple (Subwoofer) 4 m x 1

• Non-skid pads (small) x 4

• Non-skid pads (large)

– European, UK, US model x 4

– Australia, New Zealand model x 6

Standard surround

5-spot setup

This is a standard multichannel surround sound speaker

setup for optimal 5.1 channel home theatre sound.

Front

left

right

Center

Subwoofer

Surround

left

right

Listening position

Front surround

3-spot setup

This setup is ideal when rear surround speaker placement

isn't possible or you want to avoid running long speaker

cables in your listening area.

Surround

left

right

Front

left

right

Center

Subwoofer

Listening position

Caution

• Please don't use the any attachments with the

front speakers other than the brackets provided.

Connect the AM and FM antennas to the rear panel of the DVD/CD receiver.

Pull off the protective shields

of both AM antenna wires.

Push open the tabs, then insert

one wire fully into each terminal.

Release the tabs to secure the AM

antenna wires.

Fix the AM loop antenna to the

attached stand.

To fix the stand to the antenna, bend in the

direction indicated by the arrow (fig. A) then

clip the loop onto the stand (fig. B).

Note: If you plan to mount the AM antenna

to a wall or other surface, secure the stand

with screws (fig. C) before clipping the loop

to the stand. Make sure the reception is clear.

Place the AM antenna on a flat

surface and point in the direction

giving the best reception.

Don't let it come into contact with metal

objects and avoid placing near computers,

television sets or other electrical appliances.

Surround right

Surround left

(Grey)

OUT

Listening position

Subwoofer (Purple)

AUDIO

LINE 1

Center (Green)

Front left

Assembling the speaker stands and securing your front speakers

Safety precautions

Attach the speaker stand bases to the stems using the screws provided.

when setting

Before securing the base to the stand, thread the speaker wire through the holes provided on the

base as shown below. Then, once you have aligned the stem and base, secure with the small

When assembling the speakers, lay

screws at the points shown at right.

them down flat on their side to avoid

accidents or injury. Make sure to use

a stable surface when assembling,

setting up, and placing the speakers.

Caution

• Please don't use the any attachments with the front speakers

other than the brackets provided.

Attach the smaller non-skid pads to the

base of the center speaker.

Use the supplied adhesive to attach 4 pads to the

base of center speaker.

Center speaker

Attach the smaller non-

Place the surround speakers on top of the front

skid pads to the base of

speakers, turn the surround speakers towards

the center speaker.

the closest wall, lining the arrows up for

Use the supplied adhesive to

optimal Front Surround.

attach 4 pads to the base of

Turn each surround speaker so that the

center speaker.

is lined up with the

This is only necessary with the FrtMovie or

speaker.

FrtMusic modes. With ExtPower (Extra Power), the

surround speakers should be in the same direction as the

front speakers (as shown below). See the operating

instructions for more on the Front Surround modes.

Center speaker

FrtMovie / FrtMusic

fig. A

fig. B

ANTENNA

UNBAL 75Ω

LOOP ANTENNA

Connect the FM wire antenna to the FM UNBAL 75Ω antenna terminal.

For best results, extend the FM antenna fully and fix to a wall or door

frame. Don't drape loosely or leave coiled up.

The signal earth (H) is designed to reduce noise that occurs when an

Note:

antenna is connected. It is not an electrical safety earth.

Connect each speaker as shown below.

Color-coded wire

(Connect to speaker)

Color-coded connector

(Blue)

(Connect to rear panel)

Twist and pull off the protective

shields on each wire.

Connect the wires to the

speaker. Match the colored

wire with the color-coded

label (above the tabs), then

insert the colored wire into

the red (+) tab and the other

wire with the black (–) tab.

Connect the other end to the color-

coded speaker terminals on the

rear of the DVD/CD receiver (as

shown at left). Make sure to insert

completely.

Upper three terminals

The small lug at the wire-end of the

speaker plug should face up or

down depending on whether it's

being plugged into one of the

(White)

upper or lower three speaker

terminals. Please make sure to

connect correctly.

Lower three terminals

Connect the speaker system.

Refer to the Setting up your DVD/CD Receiver (the other part of this

setup guide)

to connect the speakers properly. Place them as

shown in the diagram at far left optimal surround sound.

Secure in position with the brackets provided.

Line up the holes in the bracket with the holes in the speakers, then secure

with two screws at the points shown below. Make sure you've matched the

right and left brackets with the speakers (as shown).

arrow at the base

FRONT SURROUND arrow on the front

Connect the speaker system.

Refer to the Setting up your DVD/CD Receiver (the other part of this setup guide)

connect the speakers properly.

ExtPower

Using the remote control

The remote control can be used within a range of about 7

meters (23 ft) from the remote sensor on the front panel,

and within a 30 degree angle.

Precautions:

• The remote control may not work if there is an obstacle

between the remote control and the display unit, or if the

remote control is not directed towards the remote sensor

fig. C

of the display unit at the correct angle.

• The remote control may not work properly if strong

light such as direct sunlight or fluorescent light is shining

onto the unit's remote sensor.

• The remote control may not work properly when this

unit is used near devices emitting infrared rays, or when

remote controls of other devices which use infrared rays

are used. Also, the use of this remote control may cause

other devices to work improperly.

• When the operating range of the remote becomes too

short, replace the batteries.

Remote control battery caution

Incorrect use of batteries may cause leakage or

rupture.

Always be sure to follow these guidelines:

• Always insert batteries into the battery compartment

correctly matching the positive ª and negative ·

polarities, as shown by the display inside the

compartment.

• Never mix new and used batteries.

• Batteries of the same size may have different voltages,

depending on brand. Do not mix different brands of

batteries.

• When disposing of used batteries, please comply with

governmental regulations or environmental public

instruction's rules that apply in your country or area.

• In order to prevent battery leakage, remove the

batteries when not using the remote control for an

extended period (one month or more). If leakage occurs,

carefully wipe away any battery fluid inside the

compartment, and replace the batteries with new ones.

• Do not allow books or other objects to rest on top of

the remote control, since the buttons may be depressed,

causing faster exhaustion of the batteries.

Connect the DVD/CD receiver to your TV, then connect the

supplied power cord.

Connect one end to a video input on your TV.

Use the supplied video cord.

Connect the other end to the video output of the DVD/CD receiver.

This player is equipped with copy protection technology. Do not connect this

player to your TV via a VCR using AV cables, as the picture from this player will not

appear properly on your TV.

Connect the power cord to the AC inlet.

VIDEO IN

* Illustration shows the European model

OPTICAL IN

OUT

MCACC

AUDIO

MIC

FRONT

CENTER

LINE 2

SPEAKERS

AV CONNECTOR

AUDIO

LINE 1

AC IN

SUB

SURROUND

VIDEO

WOOFER

OUT

VIDEO

AC IN

Congratulations! You're done setting up.

Printed in

/Imprimé au

Placing the Subwoofer (European, UK, US model only)

Choose your subwoofer placement

The subwoofer supplied with this

Upright position

system can be placed upright or

on its side (flat). Choose the

position that works best for your

room, then attach the large non-

skid pads as shown at right.

Attach the non-skid pads to the Subwoofer

(Australia and New Zealand model only)

Attach the large non-skid pads to the base of the subwoofer.

Use the supplied adhesive to attach 6 pads to the base of subwoofer.

: Non-skid pads

FrtMovie / FrtMusic

ExtPower

Additional notes on connecting antennas

• Keep antenna cables away from the main unit and other

cables.

• To assure optimum reception, pull the FM antenna so that it is

fully extended and not coiled or hanging at the rear of the unit.

• If reception with the supplied antenna is poor, see the Other

connections section in the main operating instructions for details

on connecting outdoor antennas.

Additional notes on speaker placement

If your listening room is of adequate size, place the speakers as

shown in step 3 to achieve the optimum surround sound effect.

If you are listening in a fairly small room and a typical surround

speaker setup is not possible, see Home theater sound setup in

the instruction manual and the Speaker Setup guide for

information on the Front surround 3-spot setup option.

When using the standard surround speaker setup as shown in

step 3, please observe the following guidelines:

• Install the main front left and right speakers at an equal

distance from the TV.

• For optimum effect, install the rear speakers slightly above ear

level.

• Install the center speaker above or below the TV so that the

sound of the center channel is localized at the TV screen.

Precautions:

• When installing the center speaker on top of the TV, be sure

to secure it with tape or some other suitable means. Otherwise,

the speaker may fall from the TV due to external shocks such as

earthquakes, endangering those nearby or damaging the speaker.

• Do not connect the supplied speakers with any other

amplifier. This may result in malfunction or fire.

• The front, center and surround speakers supplied with this

system are magnetically shielded. However, depending on the

installation location, color distortion may occur if the speaker is

installed extremely close to the screen of a television set. If this

happens case, turn the power switch of the television set OFF,

and turn it ON after 15 to 30 minutes. If the problem persists,

place the speaker system away from the television set.

• The subwoofer is not magnetically shielded and so should not

be placed near a TV or monitor. Since it is not magnetically

shielded, do not place any magnetic storage media (such as floppy

disks and tape or video cassettes) close to the subwoofer.

• Do not fix the front, center speakers and subwoofer to the

wall or ceiling; they could cause injury if they fell.

ANTENNA

UNBAL 75Ω

LOOP ANTENNA

VIDEO

OUT

VIDEO

To AC outlet

<XRE3102-A>

Flat position

Secure the speaker wire.

When you're finished, thread

the surround speaker cords

through the outlet on the

back of the speaker stand and

through the base of the

brackets as shown below.