Pioneer VSX-5400 Manuale di istruzioni per l'uso - Pagina 44
Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Ricevitore stereo Pioneer VSX-5400. Pioneer VSX-5400 47. Audio/video stereo receiver
Anche per Pioneer VSX-5400: Manuale di servizio (37 pagine)
Stampa la pagina
TROUBLESHOOTING
to carry out repair work.
Symptom
Cause
Rem dy Aer
Power does not come
switch is pressed.
on even when POWER
. ¢ Power cord is disconnected.
e Instances are rare, but the problem may be due to
the operation of the protector circuit.
ie Connect cord securely
© Unplug the power cord of the unit from the AC wall
|
outlet, th
¥ plug: it in again.
regardless of what
operation switch was
pressed.
Control was not possible
* Static electricity affected the unit when the air was
dry, such as in winter.
e Unplug the
power 'cord of the unit from 'the AC wall
|
outlet, then plug it in again.
® If static electricity is pronounced, it is recommended
that you operate the unit tusing the remote control unit.
even when the INPUT
SELECTOR switch is
selected.
No sound is produced,
¢ VOLUME switch
speaker terminals
Lo TAPEZ MONITOR switch ts in the ON position.
© Connections are incorrect.
*® The MUTE switch is pressed.
d down.
e Speaker connecting wires are disconnected from
nsult
page 6
= WV and perform connections
sorrectly.
* Press the MUTING switch to cancel the MUTING
effect.
volume.
* Connect wires to terminals sec: urely.
i
e
| * One or bo
both of the input. cords
e disconnected.
t input cords: securely.
1 & Conn
gael
e Connector bars are disconnected.
¢ Stations memorized in the STATION CALL switches
are erased,
even when the INPUT
SELECTOR switch is
selected.
L
High noise level
No picture is produced,
* Weak broadcastin
@ Connections are incorrect,
¢ The VIDEO SIGNAL SELECTOR is not set properly.
® The VCR and the selected INPUT SELECTOR
switch are not correct.
° Station has not been | tuned | in
in to correct frequency.
° Antenna has not been connected or has become
FM reception
* Accessory T-type antenna remains bundled up or it
is not pointing in right direction,
® Weak broadcasting station signals.
AM reception
* AM loop antenna is not pointing in right direction.
* Noise being picked up from this unit and other
equipment {especially electrical appliances using
motor or fluorescent lights).
again to. the OFF Pos
e * Connect bars securely.
|
"onsult your Pioneer authorized service station,
| ® Consult | page 6
correctly.
© Set correctly.
® Press the correct switch.
11 and perform connections
* Stretch beth ends of antenna taut and locate direction
Iding optimum: rece
* Replace accessory T-type antenna with outdoor
antenna.
* Change the direction of AM loop artenna and find
where reception
is improved.
sound wire
* Erect outdoor
AM antenna or connect
° Stop using
appliances
generating
noise
of remove
them from vicinity of stereo equipment.
« Separate the loop antenna from the unit by some
Gistany
No auto stop
® Input signals are not strong snough.
1
® (FM) if the T-type antenna ts being used, change to
an outdoor antenna.
TV source can't be
seen when the VCR's
TV tuner is used.
Video tape copies
can't be made with
the VCR.
tions are > faulty.
® TV antenna is not connected to VCR, or connec-
® You are attempting to watch a TV source using a
VGR with copy system connections.
in general, when copy system connections are
made, the VCR's TV tuner function ceases to
operate. For details, consult the operating instruc-
tions for your VCR.
|.
* Consult the VCR's operating instructions, and Connect
antenna corre
ly.
® Disconnect the copy system connection (TV tuner
function will operate}.
® Video tape copy connections haven't been made.
4a
<ARB1174>