Pioneer ELITE A6 Manuale di istruzioni per l'uso - Pagina 9

Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Amplificatore Pioneer ELITE A6. Pioneer ELITE A6 24. Pioneer stereo receiver operating instructions

Stampa la pagina

1. Specifications

Connecting up

Connect the analog outputs of your tape

deck (or other recorder) to the TAPE inputs

(IN) on this receiver. Then connect the audio

inputs on the tape deck to the TAPE outputs

(OUT) on this receiver.

This will allow you to make recordings from the

components connected to this receiver. Use

stereo RCA phono cables as shown.

Turntables only: Connect the audio

outputs of your turntable to the PHONO

inputs on this receiver.

• If your turntable has a grounding wire,

secure it to the ground terminal on this

receiver.

• If your turntable has line-level outputs (i.e.,

it has a built-in phono pre-amp), connect it

to the AUX inputs instead.

Connecting antennas

Connect the AM loop antenna and the FM wire

antenna as shown below. To improve reception

and sound quality, connect external antennas

(see Using external antennas below).

fig. a

FM UNBAL

Pull off the protective shields of both AM

antenna wires.

Push open the tabs, then insert one wire

fully into each terminal, then release the tabs

to secure the AM antenna wires.

fig. b

ANTENNA

AM LOOP

Fix the AM loop antenna to the attached

stand.

To fix the stand to the antenna, bend in the

direction indicated by the arrow then clip the

loop onto the stand (fig. a).

• If you plan to mount the AM antenna to a

wall or other surface, secure the stand with

screws (fig. b) before clipping the loop to

the stand. Make sure the reception is clear.

Place the AM antenna on a flat surface

and in a direction giving the best reception.

Connect the FM wire antenna in the same

way as the AM loop antenna.

For best results, extend the FM antenna fully

and fix to a wall or door frame. Don't drape

loosely or leave coiled up.

Using external antennas

To improve FM reception

Use a 75 Ω coaxial cable to connect an external

FM antenna.

One-touch

PAL connector

75 Ω coaxial cable

To improve AM reception

Connect a 5 m to 6 m (15 ft. to 18 ft.) length of

vinyl-coated wire to the AM antenna terminal

without disconnecting the supplied AM loop

antenna.

Outdoor

antenna

5 m to 6 m

(15 ft. to 18 ft.)

FM UNBAL

ANTENNA

AM LOOP

For the best possible reception, suspend

horizontally outdoors.

FM UNBAL

ANTENNA

AM LOOP

Indoor antenna

(vinyl-coated wire)