Pioneer Elite SX-A9-J Manuale di istruzioni per l'uso - Pagina 9
Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Amplificatore Pioneer Elite SX-A9-J. Pioneer Elite SX-A9-J 28. Operating instructions
Anche per Pioneer Elite SX-A9-J: Scheda tecnica (2 pagine), Manuale di istruzioni per l'uso (28 pagine)
Stampa la pagina
Connecting up
• Connect any other components (such as
1
an iPod
dock or a portable audio player) to
the AUX inputs in the same way.
2
Connect the analog outputs of your tape
deck (or other recorder) to the TAPE inputs
(IN) on this receiver. Then connect the audio
inputs on the tape deck to the TAPE outputs
(OUT) on this receiver.
This will allow you to make recordings from the
components connected to this receiver. Use
stereo RCA phono cables as shown.
3
Turntables only: Connect the audio
outputs of your turntable to the PHONO
inputs on this receiver.
• If your turntable has a grounding wire,
secure it to the ground terminal on this
receiver.
• If your turntable has line-level outputs (i.e.,
it has a built-in phono pre-amp), connect it
to the AUX inputs instead.
• Make sure the MM/MC switch is in the
proper position. If the sound of the
turntable seems loud and distorted, or
overly soft, try switching the setting.
Note
1 iPod is a trademark of Apple Computer, Inc., registered in the U.S. and other countries.
Connecting antennas
Connect the AM loop antenna and the FM wire
antenna as shown below. To improve reception
and sound quality, connect external antennas
(see Using external antennas below).
fig. a
FM UNBAL
75
5
1
Pull off the protective shields of both AM
antenna wires.
2
Push open the tabs, then insert one wire
fully into each terminal, then release the tabs
to secure the AM antenna wires.
3
Fix the AM loop antenna to the attached
stand.
To fix the stand to the antenna, bend in the
direction indicated by the arrow then clip the
loop onto the stand (fig. a).
• If you plan to mount the AM antenna to a
wall or other surface, secure the stand with
screws (fig. b) before clipping the loop to
the stand. Make sure the reception is clear.
fig. b
3
ANTENNA
AM LOOP
4
1
2
02
9
En