Pioneer GM-D8604 Manuale d'uso - Pagina 11

Sfoglia online o scarica il pdf Manuale d'uso per Amplificatore Pioneer GM-D8604. Pioneer GM-D8604 44. Bridgeable four-channel power amplifier
Anche per Pioneer GM-D8604: Manuale d'uso (15 pagine)

Stampa la pagina

Connecting the units

! This amplifier automatically selects an input

signal mode between the RCA level and the

speaker level by detecting an input signal.

Solderless terminal

connections

! Since the wire will become loose over time,

it must be periodically inspected and tigh-

tened as necessary.

! Do not solder or bind the ends of the

twisted wires.

! Fasten while making sure to not to clamp

the insulating sheath of the wire.

! Use the supplied hexagonal wrench to

tighten and loosen the terminal screw of

the amplifier and use it to securely fasten

the wire. Be careful to avoid excessive tigh-

tening of this screw, which may damage

the wire.

Connecting the power terminal

WARNING

If the battery wire is not securely fixed to the term-

inal using the terminal screws, there is a risk of

overheating, malfunction and injury, including

minor burns.

! Always use the recommended battery and

ground wire, which is sold separately. Con-

nect the battery wire directly to the car bat-

tery positive (+) terminal and the ground

wire to the car body.

! Recommended wires size (AWG: American

Wire Gauge) is as follows. The battery wire,

the ground wire and the optional direct

ground wire must be same size.

! Use a wire of 8 AWG to 16 AWG wire for the

speaker wire.

Battery wire and ground wire size

Wire length

less than 4.5 m (14 ft. 9 in.)

less than 7.2 m (23 ft. 7 in.)

less than 11.4 m (37 ft. 5 in.)

Route battery wire from engine com-

partment to the vehicle interior.

! When drilling a cable pass-hole into the ve-

hicle body and routing a battery wire thor-

ough it, take care not to short-circuit the

wire damaging it by the cut edges or burrs

of the hole.

After completing all other amplifier connec-

tions, finally connect the battery wire terminal

of the amplifier to the positive (+) battery

terminal.

1 Positive (+) terminal

2 Battery wire (sold separately)

The maximum length of the wire between

the fuse and the positive + terminal of the

battery is 30 cm (12 in.).

3 Fuse (80 A) (sold separately)

Each amplifier must be separately fused at

80 A.

Wire size

8 AWG

6 AWG

4 AWG

Section