Ariston LB6T Libro di istruzioni per l'utente - Pagina 10

Sfoglia online o scarica il pdf Libro di istruzioni per l'utente per Lavatrice Ariston LB6T. Ariston LB6T 13. Ariston built-in washing machine user instruction lb6t, lb6tx

Stampa la pagina

Installation

Transit packing

After removing the packing, check the appliance for damage.

If you have any doubts do not use the washer and call a

qualified technician. Keep the packaging components (plastic

bags, polyester foam, nails etc.) out of the reach of children

since they could be dangerous. The interior of the washer,

has an oscillating unit which is fixed on the back by 3 screws

during transport (figure 3). Before starting up the washer,

release the unit, by unscrewing the 3 screws. Seal the screw

holes with the plastic plugs supplied with the appliance.

Fig. 3

Levelling

The machine must be level in order to operate properly, To

level the machine, simply regulate the adjustable feet (fig. 4);

the angle of inclination (measured on the top of the machine)

must not exceed 2 degrees. If the washer is installed on a

carpeted floor, check that there is sufficient ventilation space

between the floor and the bottom of the machine.

Water supply

Make sure that the water pressure is between the maximum

and minimum values indicated on the data plate located on

the back of the washer. Connect the inlet hose to a cold

water tap with a 3/4 gas threaded opening, and fit the filter

and the rubber gasket supplied with the washer. Check that

it is tightly screwed to the tap (see fig. 5). If the water piping

is new or has not been udes for a long time, before making

the connection, let the water run until it is clear and free

from impurities. This step is necessary to ensure that the

incoming water does not clog and possibly damage the

washer. Connect the other end of the pipe to the appliance,

at the top on the right, by the water connection (see fig. 6).

Fig. 4

Fig. 5

Connecting the drain pipe

Connect the drain hose to a drain (with a minimum inner

diameter of 4 cm), avoiding excessive crimping or the

formation of elbows. It is important that the hose be

positioned at a height greater than 60 cm. If this is not the

case, the hose must be fastened to the hook located on the

top part of the back of the machine (fig. 7).

If a drain pipe coming from the wall is used to connect the

hose, have a qualified plumber/technician check to make

sure that it functions properly. If your home is on the top of

an apartment building or condominium, the drain may be

subject to a siphoning effect which results in the machine

filling and draining continuously. To eliminate this

inconvenience, special valves are available on the market

which can be fitted to the drain hose.

Fig. 7

Electrical connection

Before connecting the appliance to the mains, check the

following:

1) your mains socket must support then maximum power

load of the appliance, which is shown on the data plate; in

addition the socket must comply with legal regulations;

2) the supply voltage must correspond to the values shown

on the data plate;

3) the socket must be suitable for the plug of the appliance;

replace the socket or the plug but do not use an adapter;

4) home electrical systems must be earthed, in compliance

with ministerial directives. Should the electric system of your

home not comply with these directives, the manufacturer

declines any liability for any possible consequences.

Fig. 6