Ariston LV 625 A Libretto di istruzioni - Pagina 3

Sfoglia online o scarica il pdf Libretto di istruzioni per Lavastoviglie Ariston LV 625 A. Ariston LV 625 A 12.
Anche per Ariston LV 625 A: Libretto di istruzioni (12 pagine)

Stampa la pagina

Connecting the water outlet hose

Connect the outlet hose (without bending it) to a

drain duct with a minimum diameter of 4 cm.

Alternatively, rest it over a sink or tub; the free end

of the hose should not remain immersed in water.

should be between 40 and 100 cm above the ground

( see figure ).

We advise against the use of hose extensions.

Electrical connection

Before inserting the plug into the electrical socket,

make sure that:

• the socket is earthed and complies with current

regulations;

• the socket can withstand the maximum load of

the appliance, which is indicated on the data

plate located on the inside of the door ( see

Description of the appliance );

• the power supply voltage falls within the values

indicated on the data plate on the inside of the

door;

• the socket is compatible with the plug of the

appliance. If this is not the case, ask an

authorised technician to replace the plug ( see

Assistance ); do not use extension cables or

multiple sockets.

Once the appliance has been installed, the power

supply cable and the electrical socket should be

easily accessible.

The cable should not be bent or compressed.

The cable should be checked regularly and

replaced by authorised technicians only ( see

Assistance ).

The Company shall not be held responsible for any

incidents that occur if these regulations are not

observed.

The special plastic

elbow* makes it easier to

find the best layout: fix

the elbow to the wall

securely in order to

prevent the outlet hose

from moving and spilling

the dirty water.

The part of the hose

marked with the letter A

Anti-condensation strip*

After installing the dishwasher, open the door and

stick the adhesive transparent strip under the

wooden shelf in order to protect it from any

condensation that may form.

Advice regarding the first wash cycle

After the appliance has been installed, immediately

before running the first wash cycle, completely fill

the salt dispenser with water and add approximately

2 kg of salt ( see Rinse aid and refined salt ). The

water may overflow: this is normal and is not a

cause for concern. It is also normal that the LOW

SALT* indicator light continues to flash for a few

cycles after the salt has been loaded.

Technical data

width 59.5 cm

Dimensions

height 82 cm

depth 57 cm

Capacity

12 standard place-settings

Water supply

30 Kpa ÷ 1Mpa (0.3 ÷ 10 bar)

pressure

4.3 psi – 145 psi

Power supply

See appliance data plate

voltage

Total absorbed

See appliance data plate

power

Fuse

See appliance data plate

This dishwasher conforms to

the following European

Community Directives:

-73/23/EEC dated 19/02/73

(Low Voltage) and subsequent

modifications

-89/336/EEC dated 03/05/89

(Electromagnetic Compatibility)

and subsequent modifications

-97/17/EC (Labelling)

-2002/96/ CE (

Electrical and Electronic

Equipment WEEE)

* Only available in selected models.

Waste