Dinex DuraTherm 2011208 Manuale d'uso e manutenzione - Pagina 8
Sfoglia online o scarica il pdf Manuale d'uso e manutenzione per Caricabatterie Dinex DuraTherm 2011208. Dinex DuraTherm 2011208 13. 208v, 3-phase
Stampa la pagina
DuraTherm
voltage. Unplug, wait 5 seconds,
and replug unit. If error persists,
call Dinex
Message:
Critical Error! Time corrupted. Call
Dinex Service (888) 673-4639. 9
Condition:
Internal system clock time
incorrect.
Check:
System clock backup battery
dead, system clock electronics
fault, or electronic noise spike.
Cycle POWER button. Unplug,
wait 5 seconds, and replug unit. If
error persists, call Dinex
Message:
Critical Error! RFID failure. Call
Dinex Service (888) 673-4639. 15
Condition:
RFID reader-to-host
communications failure
Check:
RFID reader fault, internal power
supply electronics fault, CPU
electronics fault, bad internal
interconnect. Call Dinex
Message:
Critical Error! Electronics platform
fault. Call Dinex Service
(888) 673-4639. 16
Condition:
CPU memory corrupt.
Check:
Internal CPU fault or electrical
noise spike. Cycle power. If error
persists, call Dinex
Message:
Reheat later. (Clears when base is
removed).
Condition:
1) Insufficient base cooling
time or 2) Base time stamp has
corrupted information – but the
unit automatically repaired it.
Check:
Set base aside for reuse after one
or two hours.
8
™
service.
®
service.
®
service.
®
service.
®
MAINTENANCE
DURATHERM™ CHARGER CLEANING
INSTRUCTIONS
1. Unplug the charger before cleaning. Do
not submerge the charger in water. Do not
splash or pour water onto the charger's
control panel or into intake/outlet vents.
Possible shock hazard may result and the
charger may be damaged.
2. The heating surface is a high strength
composite material. Please use appropriate
care in handling and cleaning
3. Do not use steel wool or abrasive cleaners
or chlorinated cleaners on the charger.
4. Wipe the entire charger off with a damp
cloth and mild detergent. Dry the charger
before connecting it to its electrical source.
GREASE AND AIR FILTERS
1. Weekly, inspect the two bottom-mounted
grease filters for build-up of debris.
2. Slide filters out or their holders and run
under faucet or in dishwasher to clear of
debris and grease. FILTERS MUST BE
DRY BEFORE SLIDING BACK INTO THEIR
HOLDERS. DO NOT OPERATE YOUR
DURATHERM™ WITHOUT PROPERLY
FITTED, DRY FILTERS.
3. Replacement filters may be obtained by
calling Dinex
service.
®
WARNING: Never spray, wash or use excessive
water on the charger. Before cleaning it is
absolutely necessary to unplug power plug.
• Do not use the charger if the top is broken
or cracked.