Aeotec MULTISENSOR 6 Manuale d'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale d'uso per Accessories Aeotec MULTISENSOR 6. Aeotec MULTISENSOR 6 13. Z-wave water and flood sensor
Anche per Aeotec MULTISENSOR 6: Manuale (3 pagine), Manuale d'uso (8 pagine), Manuale (10 pagine), Manuale d'uso (13 pagine)

Stampa la pagina

For a battery powered installation;

1. Remove the rear part of your sensor as shown in the previous

step 1.

2. Insert CR123A batteries oriented according to the picture below.

Your MultiSensor is now powered on.

Add your MultiSensor to your Z-Wave network.

It's now time to sync your MultiSensor with a Z-Wave network. The

following instructions explain how to do this using a Z-Stick or a

Minimote from Aeotec. If you're using an alternative controller for

your Z-Wave network, please refer to its user manual for network

inclusion instructions.

If you're using a Z-Stick:

Security or Non-security feature of your MultiSensor in

Z-wave network.

If you want your MultiSensor as a non-security device in your

Z-wave network, you just need to press the Action Button once on

MultiSensor when you use a controller/gateway to add/include your

MultiSensor.

In order to take full advantage of all functionality the MultiSensor,

you may want your MultiSensor is a security device that uses

secure/encrypted message to communicate in Z-wave network, so

a security enabled controller/gateway is needed for the Multisensor

to be used as a security device.You need to press the MultiSensor's

Action Button 2 times within 1 second when your security controller/

gateway starts the network inclusion.

Resetting your MultiSensor.

At some stage or your primary controller is missing or inoperable,

you may also wish to reset all of your MultiSensor's settings to their

factory defaults. To do this, press and hold the Z-Wave Button for

20 seconds and then release it. Your MultiSensor will now be reset

to its original settings, and the LED will stay solid for 2 seconds and

then turn off as a confirmation.

Technical specifications.

Model number: ZW100

Power Supply: USB DC 5V or battery power(2×CR123A batteries,