Ariston Piccolo ARKS 50 Istruzioni per l'installazione Manuale - Pagina 12

Sfoglia online o scarica il pdf Istruzioni per l'installazione Manuale per Scaldabagno Ariston Piccolo ARKS 50. Ariston Piccolo ARKS 50 20.

Advice for user

- Avoid positioning any objects and/or appliances that could be damaged by water

leaks beneath the water heater.

- Should you not use any water for an extended period of time, you should:

disconnect the appliance from the electrical supply by switching the external

switch to "OFF";

turn off the plumbing circuit taps.

- Hot water at above 50°C flowing out of the taps at the point of use could cause

serious scalds or even death from burns. Children, the disabled and the elderly are

more exposed to the risk of burns.

- It is strictly forbidden for the user to perform any routine or extraordinary maintenance.

- Before calling the after-sales service centre for assistance in the event of a suspected

malfunction, check first whether this is due to other causes, such as for example a

temporary power failure or water shortage.

See warning nos. 1 - 2 - 3

See warning no. 4 – Contact a competent person for the replacement of the

power supply cable.

See warning nos. 5 - 6 - 8

See warning no. 21 - To clean the outer parts of the appliance, use a damp

cloth soaked in soapy water.

See warning no. 21 - To clean the outer parts of the appliance, use a damp

cloth soaked in soapy water.

See warning nos. 22 - 23

Operation

To turn the water heater on, insert the plug into the wall socket or switch on the bipolar

switch.

The pilot lamp (A fig. 4) only stays on during the heating cycle; during this time, the

expanding water could cause some water to trickle from the tap: this is completely

normal and does not mean the tap is faulty. Do not screw the taps too tightly to

prevent damaging their seals.

The thermostat will automatically disable the heating element as soon as the selected

water temperature is reached.

During the final stage of heating, it is normal for a few cycles of thermostat starting

and stopping to take place.

During normal operation, the electric heating element may make a little noise inside

the appliance, which is due to the heat exchange; the plumbing connections may also

become hot to the touch.

Adjusting the operating temperature

The temperature of the water can be selected on the knob (F fig. 6) and can be adjusted

from 40 to 80°C approximately.

We recommend you set the temperature of the water heater to 60°C to:

- reduce the formation of limescale;

- reduce heat dispersion;

- avoid the risk of bacteria proliferation.

Supplied By www.heating spares.co Tel. 0161 620 6677