Aeotec ZW162 Manuale d'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale d'uso per Accessories Aeotec ZW162. Aeotec ZW162 7.

You will be able to manually test your Doorbell 6 unpaired or paired to a Z-Wave network, to determine if its sound is

working, perform the button action listed below:

Press and hold Action Button down for 2-5 seconds

Safety: Test only when wearing necessary ear protection. Doorbell 6's speaker emits tones up to 105dB that can

cause hearing damage.

Reset your Doorbell.

This method is not fully advised unless your gateway has failed, and you do not yet have another gateway to perform

a general unpair on Doorbell 6.

To do this, follow the steps below:

1. Press and hold the Action button for 20 seconds

2. [2-5 seconds], the test Doorbell sound will run, then stop after 5 seconds has passed.

3. [5-20 seconds] The LED will continue to blink faster (5 to 10 seconds) and faster (10 to 20 seconds).

4. [21 seconds and later] The LED will then quickly flash 3 times then will have LED breath in and out as you hold

down the Action Button

5. Release the Action button, and the Doorbell 6 will factory reset.

Add more buttons to Doorbell 6.

Doorbell 6 supports up to 3 Aeotec Buttons. Doorbell 6 already comes with one Aeotec Button, which you can

purchase 2 additional Aeotec Button to pair and control a single Siren/Doorbell 6 sound unit.

You can learn how to pair more Aeotec Button to Doorbell 6

here: https://aeotec.freshdesk.com/solution/articles/6000202225-aeotec-button-user-guide-

(https://aeotec.freshdesk.com/solution/articles/6000202225-aeotec-button-user-guide-)

More Advanced Configurations.

You can find more advanced configurations for Siren 6 in our Engineering Sheet section on our Freshdesk which can

be used to integrate Siren 6 into a new gateway or software, or use it as a reference for configurations.

More Advanced Configuration settings and function use.

(https://aeotec.freshdesk.com/helpdesk/attachments/6086176996)

Using Doorbell 6 with SmartThings hub.

krlaframboise has created a custom device handler to be used with SmartThings hub with all functions and use cases

integrated. You can find instructions on how to install the custom device handler here and how to configure your Siren

6 to your needs

https://aeotec.freshdesk.com/solution/articles/6000223182-aeotec-doorbell-6-with-smartthings-hub-

(https://aeotec.freshdesk.com/solution/articles/6000223182-aeotec-doorbell-6-with-smartthings-hub-)