Aeotec ZWA041 Manuale d'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale d'uso per Accessories Aeotec ZWA041. Aeotec ZWA041 9.

18/06/2021

Advances functions.

Z W

Firmware-Update over the Air.

This device is capable of receiving a new firmware 'over the air'. The update function needs to be supported by the central

controller. Once the controller starts the update process, perform the following action to confirm the firmware update:

Wake Up the device by removing the cover.

The hit the tamper switch once.

Send a wake-up notification.

In order to send your sensors new configuration commands from your Z-Wave controller or gateway, it will need to be

woken up.

Wake Up the device by removing the cover.

The hit the tamper switch once.

Note: Door / Window Sensor 7 Basic remains awake until the housing is closed again.

Remove your Door / Window Sensor 7 Basic from Z-Wave network.

Your sensor can be removed from your Z-Wave network at any time. You'll need to use your Z-Wave network's main

controller/gateway. To do this, please refer to the part of your gateway's respective manual that tells you how to remove

devices from your network.

Set your Z-Wave controller into unpair mode.

Triple-click the tamper switch on Door / Window Sensor 7 within 1.5 seconds - this will cause the LED to blink five

times.

After a successful exclusion, it will light up its LED for 2 seconds then deactivate.

Reset your Door / Windows Sensor 7 Basic.

This device also allows being reset without any involvement of a Z-Wave controller. This procedure should only be used

when the primary controller is inoperable.

To manually factory reset:

https://help.aeotec.com/support/solutions/articles/6000230382-door-window-sensor-7-basic-user-guide-zwa011-zwa041-

Aeotec Door Window Sensor 7 Basic guide : Aeotec Help Desk

6/9