Aeotec Dual Nano Switch ZW132 Manuale d'uso - Pagina 15

Sfoglia online o scarica il pdf Manuale d'uso per Interruttore Aeotec Dual Nano Switch ZW132. Aeotec Dual Nano Switch ZW132 15.

Stampa la pagina

8-7-2019

If you want your Dual Nano Switch as a non-secure device in your Z-Wave network, press the Action Button once on Dual Nano Switch when you pair it to your gateway.

If inclusion is successful, the green LED will be on for 2 seconds, and then return to a solid indication. If inclusion is unsuccessful, the red LED will be on for 2 seconds and

then return to a colorful gradient.

Including Dual Nano Switch as a secure device:

In order to take full advantage of the Dual Nano Switch, you will want your Dual Nano Switch as a security device that uses encrypted messages to communicate in your

Z-wave network. A security enabled controller/gateway (or Z-Wave Plus controller) is required.

1. Set your Z-Wave Plus controller into pairing mode.

2. Press the Action Button 2 times within 1 second on the Dual Nano Switch, the blue LED (secure indication) will blink to indicate the Dual Nano Switch is entering into

secure pairing mode.

3. If the Dual Nano Switch has been successfully added to your Z-Wave network, its RGB LED will be solid. If the pairing was unsuccessful, the red LED will be on for 2

seconds and then remain a colorful gradient, repeat the instructions above

from step 1.

Reset your Dual Nano Switch.

If at some stage, your primary controller is missing or inoperable, you may wish to reset all of your Dual Nano Switch's settings to their factory defaults.

To do this, press and hold the Action Button for 20 seconds and then release it. Your Dual Nano Switch will now be reset to its original settings, and the green LED will be solid

for 2 seconds and then remain the colorful gradient status as a confirmation.

https://aeotec.freshdesk.com/support/solutions/articles/6000178928-dual-nano-switch-user-guide-zw132-and-zw140-

Dual Nano Switch user guide : Aeotec Group

15/15