Dini Argeo HLD Series Manuale operativo - Pagina 9
Sfoglia online o scarica il pdf Manuale operativo per Bilance Dini Argeo HLD Series. Dini Argeo HLD Series 13. Laboratory scale, industrial weighing systems
Stampa la pagina7.1 SET-UP ENVIRONMENT BLOCK DIAGRAM
SETUP
ENVIRONMENT
7.2 F1 Unt CONFIGURATION OF SECONDARY UNITS OF MEASURE
By pressing ZERO it's possible to choose the units of measure for the conversion function (see section 6.8), enabling
(on) or disabling (oFF) the suggested secondary units of measure:
1) The display proposes the first secondary unit of measure to be enabled or disabled.
2) Press MODE to change the options and confirm with ZERO, or press PRINT/M+ to exit without confirming and
pass to the following unit.
3) The display proposes the 2nd secondary unit to be enabled or disabled.
4) Proceed as described in point 2 up until the last proposed unit of measure.
7.3 F2 bL DISPLAY BACKLIGHTING
EL oFF backlighting always off
EL on
backlighting always on.
EL AU
backlighting on only when the weight is greater than 20d or when a key is pressed. When a key is pressed,
if the weight is less than 20d, the backlighting remains active for 5 seconds.
F1 unt
EL on, EL AU,
F2 bL
F3 CoM
Printer port
Transmission
Printer type
tEch
g
Ut on, Ut oFF
...
Ut on, Ut oFF
n
Ut on, Ut oFF
EL oFF,
232, USB
P Prt, P Cont,
mode
b600, b1200,
baud
b2400, b4800,
tP, LP-50
Pin
10
P AUto,
WirELE
b9600
P1 Lin
P2 CAL
P3 Cnt
P4 Azn
P5 GRA
X.XXXXX
P6 CAP
3000, 6000
XXXXXX
0.5d, 1d,
2d, 4d
150, 300,
600, 1500,