Aeotec WallMote Manuale d'uso - Pagina 8

Sfoglia online o scarica il pdf Manuale d'uso per Controllore Aeotec WallMote. Aeotec WallMote 9.
Anche per Aeotec WallMote: Manuale d'uso (8 pagine), Avvio rapido (3 pagine)

Stampa la pagina

29/10/2019

Your WallMote has a internal rechargeable lithium battery that will allow you to charge it when it is in low battery. The

charger's output should be a micro USB terminal with the specification of output DC 5V/1A. When the WallMote is in

charge state, the orange LED will be on. If the orange LED is off and the green LED remains on, then it indicates that

the battery charge is complete.

Note: When the WallMote is in low battery, you will see the orange LED will blink when you touch the control buttons.

Otherwise, if the blue LED blinks when touching the buttons, which means the battery is in normal level.

Waking up WallMote.

In order to configure WallMote, you must either (1) wake up WallMote using the below button press function.

1. Press and hold WallMote Action button

2. Wait until the RGB LED turns into a Yellow/Orange Color and beeps.

3. Release WallMote Action Button

The LED on WallMote will now rapidly blink its Yellow/Orange LED while it is in its awake state. You may send in any

configurations or commands from your current gateway to configure your WallMote.

4. Tap the Action Button on WallMote to put WallMote back to sleep, or wait 10 minutes. (recommended to manually put

it back to sleep to conserve battery life).

Testing Health Connectivity.

You can determine the health of your WallMotes connectivity to your gateway using a manual button press, hold, and

release function which is indicated by the LED color. This will help you maximize the battery life based on the health of

your WallMotes communication to your gateway. You'll be able to see a maximum battery use of 3 months of use over

green LED indication listed below.

1. Press and hold WallMote Action button

2. Wait until the RGB LED turns into a Purple Color

3. Release WallMote Action Button

The RGB LED will blink its Purple color while sending ping messages to your gateway, when it has finished, it will blink

1 of 3 colors:

Red = Bad Health

Yellow = Moderate Health

Green = Great Health

Be sure to watch for the blink, as it will only blink once very quickly.

Resetting your WallMote.

If at some stage, your primary controller is missing or inoperable, you may wish to factory reset your WallMote which

will remove it from its network that it is paired to, and reset all configured settings back to default. To do this, follow the

steps below:

1. Press and hold the Action button (20 seconds).

2. The LED should blink between green, purple, then red which will flash rapidly until a green LED becomes solid for 2

seconds to indicate a successful factory reset.

3. Let go of the Action Button.

https://aeotec.freshdesk.com/support/solutions/articles/6000176572-wallmote-user-guide-

Aeotec Wallmote user guide : Aeotec Group

8/9