Aeotec MultiSensor 7 Manuale d'uso - Pagina 7

Sfoglia online o scarica il pdf Manuale d'uso per Sensori di sicurezza Aeotec MultiSensor 7. Aeotec MultiSensor 7 8.
Anche per Aeotec MultiSensor 7: Manuale d'uso (5 pagine)

Stampa la pagina

22/07/2021

3. If reset successful, the blue led will fade in and out

Waking up MultiSensor 7.

In order to conﬁgure Multisensor 7, you must either (1) wake up Multisensor 7 using the below button press function,

or (2) temporarily put your Multisensor 7 on USB power.

This section will go over manual wakeup of this sensor for the case you don't want to wait for conﬁguration.

Quick Wakeup.

Z W

Long Wakeup.

1. Press and hold Multisensor 7 Action button

2. Wait until the LED turns into a solid

3. Release Multisensor 7 Action Button, the LED should remain solid orange while it is awake. Send any

conﬁgurations from your hub (assuming the commands are not queued).

If the MultiSensor 7 LED orange LED turns oﬀ right away, this would indicate that your hub is putting

your device to sleep. Try unpowering your hub temporarily, follow steps 1-3 again, then power up your

hub again.

4. Tap the Action Button on Multisensor 7 to put Multisensor 7 back to sleep, or wait 5 minutes. (recommended

to manually put it back to sleep to conserve battery life).

Advanced settings of MultiSensor 7.

There are further advanced parameter settings and group association settings not listed in this guide. You can ﬁnd the

attachment of the advanced engineering sheet of the MultiSensor 7 which will give you all possible functions of the

MultiSensor 7 that may be missing in this guide.

The PDF guide will feature these missing advanced settings:

Parameter settings (Conﬁguration Command Class)

Group Association (Association Command Class)

https://aeotec.freshdesk.com/support/solutions/articles/6000232605-multisensor-7-user-guide

MultiSensor 7 user guide : Aeotec Help Desk

color (2 - 5 seconds)

7/8