Aeotec Z-Stick Gen5 Manuale - Pagina 4
Sfoglia online o scarica il pdf Manuale per Adattatore Aeotec Z-Stick Gen5. Aeotec Z-Stick Gen5 11. Z-wave usb adapter
Anche per Aeotec Z-Stick Gen5: Manuale (2 pagine), Manuale d'uso (5 pagine)
Stampa la pagina
Stick and press the button on the device you wish to include. (The blue LED on the Z‐Stick
will blink fast during a network neighbour discovery and stay solid for 2 seconds to indicate
successful inclusion of the device into the network.)
3. The blue LED will then return to blinking slowly, indicating readiness for further device
inclusions. Repeat step 2 for each device as you wish to include.
4. Tap the Z‐Stick's Action Button to turn it off or it will automatically exit the removal
mode after 30 seconds.
Removing/Excluding Z‐Wave Devices from the Z‐Wave Network:
Press and hold
1. Unplug the Z‐Stick from the USB connector. Then press and hold the Action Button for
2 seconds and
approximately 2 seconds. (The orange LED will blinking fast.)
releasing
2. To remove a Z‐Wave device from the network, simply go to the device with the Z‐Stick
and press the Action Button on the device you wish to remove. (The LED on the Z‐Stick will
become blue and Immediately stay solid for 2 seconds to indicate successful removal from
the network.)
3.
The orange LED will then return to blinking fast, indicating readiness for further device
exclusions. Repeat step 1 for each device as you wish to exclude.
Reset Z‐Stick to factory Default:
Press and hold
1. Unplug the Z‐Stick from the USB connector.
20 seconds
2. Press and hold the Action Button for 20 seconds.
3. If holding time more than one second, the LED will become red, then blink faster and
faster. If holding time more than 20 seconds, the LED will become blue and stay solid for 2
seconds, it indicates reset success, otherwise please repeat step 2.
Note: Reset Z‐Stick to factory default Settings will: exclude the Z‐Stick from the Z‐Wave
network; restore the configuration settings to the default.
4.2 Function of Reset Button
Button action
Click one time
Reset the USB port.
4.3 Function of SerialAPI‐Mode
Plug the Z‐Stick into the USB connector of the host, the Z‐Stick will initiate SerialAPI‐Mode, it is always
listening (awake and always in RX receive mode) and acts as a Z‐Wave adapter and responds to commands
sent through USB by the host processor software.
5. Special Functions of Z‐Stick
5.1 Factory reset
You can through one of the following ways to perform this function:
1. At some stage, you may wish to reset all of your Z‐Stick's settings to their factory defaults. To do this,
press and hold the Reset Button for 20 seconds and then release it. The Z‐Stick will now be reset to its
original settings, and the blue LED will solid for 2 seconds as confirmation.
2. The Z‐Stick also can be reset to the factory defaults settings via the host software. To do this, the host
software must take control of the Z‐Stick USB adapter while the Z‐Stick is in SerialAPI‐Mode. Please
consult the instruction manual of the host software to perform a network reset (i.e. factory reset on the
Z‐Stick).
5.2 Add Z‐Stick to a pre‐existing Z‐Wave network
Description