Ariston MBA 3311 Manuale di installazione e uso - Pagina 3

Sfoglia online o scarica il pdf Manuale di installazione e uso per Frigorifero Ariston MBA 3311. Ariston MBA 3311 17. Fridge/freezer combined

Stampa la pagina

1. Close-Up View

Safety - a good habit to get into.

ATTENTION

Read your manual carefully since it contains instructions

which will ensure safe installation, use and maintenance of

your appliance.

Your Refrigerator is built to International safety standards

(EN60) ans has been awarded the European approval mark

(IMQ) for compliance with UK electrical safety requirements.

It also meets the EC standards on the prevention and elimi-

nation of readio interference (EC directive 87/308 - 02.06.89).

1. This appliance must not be installed outdoors - not even in

an area protected by a roof. It is extremely dangerous to leave

it exposed to rain or storms.

2. It must only be used by adults and exclusively to refrigerate

and freeze foodstuffs, following the instructions for use con-

tained in this manual.

3. Do not ever touch or handle the appliance with bare feet or

with wet hands or feet.

4. It is highly recommended that you do not use extension

cords or multiple socket adapters. If the refrigerator is installed

between cabinets, make sure that the cord is not bent or dan-

gerously pinched or compressed.

5. Never pull on the cord or the refrigerator to remove the plug

from the wall socket - this is very dangerous.

6. Never touch the cooling components within the appliance,

especially with wet hands because this could result in injury.

Never put ice cubes just removed from the freezer into your

Installation

Proper installation of the appliance is essential to en-

sure the best and most efficient performance of your

appliance.

Ventilation

The compressor and condenser generate heat and, there-

fore, need to be ventilated properly. Rooms with less than

perfect ventilation are not very suited for installation of the

appliance. Therefore, it should be installed in a room with

an opening (window or French window) that provide the

appropriate amount of air re-circulation. It is also important

that the room not be too humid.

During installation, make sure not to cover or obstruct the

grates that allow for proper ventilation of the appliance.

For proper ventilation of the appliance, you must leave:

- a space of at least 10 cm between the top part and any

cabinets above it;

- a space of at least 5 cm between the sides of the appliance

and any adjacent cabinets/walls.

Away from Heat

Avoid positioning the appliance in a place where it is directly

exposed to sunlight or near an oven, cook top or the like.

mouth because they could stick to your mouth and cause burns.

7. Do not carry out any cleaning or maintenance operations

without first having disconnected your appliance from the mains

power supply (by unplugging it or turning off the cut-out switch

in your home); turning the thermostat knob to " " is not

enough to eliminate all electric contacts.

8. Before having your old refrigerator picked up for disposal,

remove or make inoperable any locking devices to prevent chil-

dren who might play in or around the appliance from being

locked inside.

9. Before calling for service/assistance in the case of malfunc-

tion, consult the chapter entitled "Is There a Problem? to de-

termine whether it is possible to eliminate the problem. do not

try to repair the problem by trying to access the internal com-

ponents of the appliance.

10. If damaged, the power supply cord on this appliance must

necessarily be replaced by our service centre because special

tools are required for replacement.

11. Do not use electric appliances inside the compartment for

food storage, if these are not those recommended by the

manufacturer.

12. At the end of the functional life of your appliance –

containing cyclopentane gas in the insulation foam and perhaps

gas R600a (isobutane) in the refrigeration circuit – the latter

should made safe before being sent to the dump.

For this operation, please contact your dealer or the Local

Organisation in charge of waste disposal.

Levelling

The floor should be perfectly level; if not, you can adjust the

feet at the front of the appliance.

Earthing

Before making the electrical connection, check that the volt-

age shown on the data plate, that you will find on the bot-

tom left hand side of the appliance next to the crisper, cor-

responds to that of your home and that the socket is earthed

in compliance with all current electrical regulations. If the

system is not earthed, the manufacturer declines all liability

for consequent damages or losses. Do not use adapters or

multiple sockets.

Position the appliance in such a way that you can access

the socket where it is plugged in.

Check the power load

The electrical socket must support the maximum power load

of the appliance shown on the data plate (on the bottom

left hand side of the appliance next to the crisper).

Before plugging the appliance to the mains

Stand the appliance upright and wait at least 3 hours before

plugging the appliance into the mains to ensure proper per-

formance.