Whirlpool 3358974 Manuale di istruzioni per l'installazione - Pagina 3

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Lavatrice Whirlpool 3358974. Whirlpool 3358974 6.

Stampa la pagina

Now start...

With washer in laundry area.

completely

out bf the

wagher.

1. @--&

Read, then remove label that covers

drain connector.

Pull to completely

remove the shipping strap with 2 cotter

pins from the inside of the washer.

Pull firmly to remove the other I' '

end of shipping strap from the back of

the washer. The shipping strap plug must

be completely

removed from the washer

for the self-leveling legs to be released.

Save the shipping strap for use in Step 16.

Use new hoses and washers that came

with your Whirlpool washer.

coupling

washer

Insert a flat washer into each end of the

inlet hoses. Check that washers are firmly

seated in couplings.

I Attach hose (without adaptor) to

bottom inlet valve opening first; then

second hose (without adaptor) to top inlet.

Tighten couplings by hand. Then use pliers

to make an additional

two-thirds turn.

IMPORTANT: THIS PROCEDURE MUST BE

FOLLOWED TO ASSURE PROPER

INSTALLATION.

To prevent the drain hose from

n coming off or leaking, it must be

installed per the following instructions:

1. Wet the inside end of the drain hose

with tap water. DO NOT USE ANY

OTHER LUBRICANT.

Panel B

Numbers

correspond to

steps.

2. Squeeze ears of clamp with pliers to

open and place clamp over the

end of the drain hose.

3. While holding clamp open, work

end of drain hose onto drain

connector

until drain hose is within

l/4 inch (0.64 centimeters) of ribbed

stop.

4. Position clamp over the drain hose

area marked "clamp."

Release

clamp. Clamp should be l/4 inch

itO.,centimeters)

from end of drain

Open

n clamp and

slide over "hook"

end of drain hose

to secure the rigid

and corrugated

sections together.

Floor Damage

Slide washer onto cardboard

hardboard

before moving across floor.

Failure to do so may cause damage to

floor covering.

Move washer close to final

n position. Put "hook" end of drain

hose into laundry tub or standpipe.

Check for proper length of drain hose.

n DO NOT FORCE EXCESS LENGTH OF

DRAIN HOSE DOWN THE STANDPIPE. THIS

COULD CAUSE SIPHONING.

Before attaching

water inlet

n hose, run water through both

faucets into a bucket.

This will get rid of

particles in the water lines that might clog

hoses. Mark which is the hot water faucet.

coupling

washer

adaptor

Attach bottom hose with

n adaptor (inlet marked 'H') to hot

water faucet.

Attach top hose with

adaptor (inlet marked "C') to cold water

faucet.

Tighten couplings to faucet by

hand; then use pliers to make final

two-thirds turn.