Whirlpool 8316473A Manuale di istruzioni per l'installazione - Pagina 7

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Lavatrice Whirlpool 8316473A. Whirlpool 8316473A 8.

Install the Front Leveling Feet

1. Prop up the front of the washer about 10.2 cm (4") with a

wood block or similar object. The block needs to support the

weight of the washer.

A. Threaded holes for feet

2. Screw the locknut onto each foot to within 2.5 cm (1") of the

foot base.

2.5 cm

(1")

3. Screw the feet into the threaded holes at the front corner of

the washer until the nuts touch the washer. Twist the feet to

install.

NOTE: Do not tighten the nuts until the washer is level.

4. Tilt the washer back and remove the wood block. Gently lower

the washer to the floor.

Level the Washer

Properly leveling your washer avoids excessive noise and vibration.

10.2 cm

(4")

Steps in Final Location

1. Slide the washer to its final location.

2. Tilt the washer forward until the rear of the washer is at least

10.2 cm (4") off the floor. You may hear the self-adjusting rear

feet click into place. Lower the washer to the floor.

A. Self-adjusting feet

3. Check the levelness of the washer by placing a level on the

top edges of the washer, first side to side, then front to back.

4. If the washer is not level, move the washer out slightly, tip

back, prop up the front of the washer with the wood block

and adjust the feet up or down as necessary by twisting the

feet. Turn the feet clockwise to raise the washer or

counterclockwise to lower the washer. Repeat steps

1 through 4 until washer is level.

5. After the washer is in its final location and level, use a 14 mm

or ⁹⁄₁₆" open-end wrench to turn the nuts counterclockwise on

the feet tightly against the washer cabinet.

IMPORTANT: If the nuts are not tight against the washer

cabinet, the washer may vibrate.

10.2 cm

(4")