Whirlpool 859991536160 Manuale d'uso - Pagina 15
Sfoglia online o scarica il pdf Manuale d'uso per Lavatrice Whirlpool 859991536160. Whirlpool 859991536160 19.
Stampa la pagina
User manual
TROUBLESHOOTING
Your washing machine is equipped with various automatic
safety and feedback functions . They enable failures
and needed maintenance to be detected and indicated
accordingly .
Anomalies:
The washing machine does not
turn on .
The wash cycle does not start .
The washing machine does not fill
with water (the message "h2o" is
shown on the display) . "Beep"
sound every 5 seconds .
The washing machine loads and
drains water continuously .
The washing machine does not
drain or does not spin .
The washing machine vibrates
excessively during the spin cycle .
The washing machine leaks water .
The machine is locked and the
display flashes, indicating an
error code (e .g . F-01, F- . .) .
Too much foam is formed .
Door is locked, with or without
failure indication, and the
programme does not run .
Possible causes / Solution:
•
The plug is not inserted into the electrical outlet, or not enough to make contact .
•
There has been a power failure .
•
The door is not fully closed .
•
The "ON/OFF"
button has not been pressed .
•
The "Start/Pause"
button has not been pressed .
•
The water tap is not open .
•
A "Start delay"
has been set .
•
The water intake hose is not connected to the tap .
•
The hose is bent .
•
The water tap is not open .
•
The mains water supply has been shut off .
•
There is not enough pressure .
•
The "Start/Pause"
button has not been pressed .
•
The drain hose has not been installed at 65 to 100 cm from the ground .
•
The end of the drain hose is immersed in water .
•
The drain connector on the wall does not have an air vent .
•
If the problem persists after having performed these checks, close the water tap,
shut off the washing machine, and call the After-sales service . If the dwelling is
located on one of the uppermost floors of a building, a siphon effect can
sometimes occur, thus causing the washing machine to load and drain water
continuously . Special anti-siphon valves are available on the market to prevent
these types of problems .
•
The programme does not include the draining function: with certain programmes
it must be activated manually .
•
The drain hose is bent .
•
The drain line is obstructed .
•
At the time of installation, the drum was not properly
•
The washing machine is not level .
•
The washing machine is squeezed between furniture and the wall .
•
The water intake hose has not been tightened properly .
•
The detergent dispenser is clogged .
•
The drain hose has not been properly fastened .
•
Shut off the machine, disconnect the plug from the outlet, and wait about 1
minute before turning it back on .
•
If the problem persists, call the After-sales service .
•
The detergent is not compatible with the washing machine (it must bear the
wording "for washing machines", "for hand washing and washing machines", or
something similar) .
•
The dosage was excessive .
•
Door is locked in case of power breakdown . Programme will continue
automatically as soon as the mains is available again .
•
Washing machine is in a standstill . Programme will continue automatically after
the origin of the standstill does not persist anymore .
These failures are frequently so minor that they can be
removed within a few minutes .
EN
unblocked .
15