Whirlpool WASHER Manuale di istruzioni per l'installazione - Pagina 7

14.

Secure drain hose

Laundry Tub

Standpipe

Secure drain hose to laundry tub leg, drain standpipe or inlet

hoses for wall standpipe with beaded tie strap.

LeveL Washer

Leveling your washer properly reduces excess noise and

vibration.

15.

Prepare to install leveling feet

Prop up front of washer about 4" (102 mm) with a wood block

or similar object that will support weight of washer. Then screw

locknut onto each foot to within 1" (25 mm) of foot base.

16.

Install front leveling feet

Screw feet into threaded holes at front

corners of washer until jam nuts touch washer, but are not tight.

Wall

Tilt washer back, remove wood block. Gently lower washer to

floor and slide washer to its final location. Remove cardboard

used to protect floor. Tilt washer forward, self-adjusting rear feet

will click into place. Gently lower washer to floor.

(25 mm)

Place a level on top edges of washer, checking each side

and front. Rock washer back and forth to make sure all four

feet make solid contact with floor. If not level, tip washer and

adjust feet up or down, repeating as necessary.

17.

Engage rear leveling feet

18.

Check levelness of washer

place level here

Not Level

LEVEL

Not Level