Whirlpool WASHER Istruzioni per l'utente - Pagina 13

Sfoglia online o scarica il pdf Istruzioni per l'utente per Lavatrice Whirlpool WASHER. Whirlpool WASHER 15. Washing machine
Anche per Whirlpool WASHER: Manuale di istruzioni per l'installazione (16 pagine), Manuale di istruzioni per l'installazione (27 pagine), Istruzioni per l'utente (8 pagine), Istruzioni per l'utente (20 pagine), Istruzioni per l'utente (24 pagine), Istruzioni per l'utente (8 pagine), Manuale di istruzioni per l'installazione (20 pagine), Manuale d'uso e manutenzione (40 pagine), Manuale di istruzioni per l'installazione (16 pagine), Istruzioni per l'utente (8 pagine), Grafico del programma (2 pagine), Istruzioni per l'installazione (5 pagine), Manuale di istruzioni per l'installazione (8 pagine)

Stampa la pagina

Whirlpool WASHER Istruzioni per l'utente

Before You Start

WARNING

Excessive Weight Hazard

Use two or more people to move and install washer.

Failure to do so can result in back or other injury.

To prevent floor damage, set the washer onto cardboard

before moving across floor.

Move the washer to within approximately 90 cm of the final

location.

Remove Shipping Strap

Removing the shipping strap is necessary for smooth operation. If

the shipping strap is not removed, the washer will make excessive

noise. The washer must be in the upright position before removing

the shipping strap.

1. Do not cut yellow strap. Pull yellow strap firmly, until

completely removed from washer. There will be two cotter

pins on the end of the shipping strap when it is pulled out of

the washer.

2. Pull firmly to remove the end of the shipping strap that

remains pinned to the back of the washer. This will release the

rear self-leveling feet.

3. Cut the shipping strap about 40 cm from plug end. Look for

the words "CUT HERE." Discard end with the cotter pins. You

will use the remainder of the shipping strap later to secure the

drain hose.

40 cm

INSTALLATION INSTRUCTIONS

Connect Drain Hose

Proper connection of the drain hose will protect your floors from

damage due to water leakage. To prevent the drain hose from

coming off or leaking, it must be installed per the following

instructions.

IMPORTANT: To ensure proper installation, this procedure must

be followed exactly.

1. Check the drain hose to see that it is the proper length.

2. Wet the inside of the straight end of the drain hose with tap

water. DO NOT USE ANY OTHER LUBRICANT.

3. Squeeze ears of silver, double-wire clamp with pliers to open.

Place clamp over the straight end of the drain hose 6 mm from

the end.

4. Open clamp. Twist hose back and forth while pushing down

onto drain connector at the bottom of the washer. Continue

until hose contacts the ribbed stop on the cabinet.

5. Place clamp over area marked "CLAMP." Release clamp.

6 mm

A. Drain Hose

B. Clamp

6 mm

C. Ribbed stop

D. Cabinet